Примеры использования Ready light на Английском языке и их переводы на Русский язык
{-}
-
Official
-
Colloquial
Flowchart 5: Ready Light Steady Green.
Wait until the iron ready light stays on continuously.
The Ready light is in the upper right corner of the receiver.
Go to Flowchart 2: Ready Light Not On on page 43.
See page 21 for more information about Ready light states.
Flowchart 4: Ready Light Flashing Green.
After a minimum of two minutes, the green ready light turns on.
With this setup, the Ready light on your interactive whiteboard will.
As soon as the selected temperature has been reached, the green ready light C will go on.
Wait until the iron ready light stays on continuously.
The ready light will illuminate when the desired temperature is reached.
The following table shows the Ready light's normal states.
When the ready light of the flash is illuminated, the unit is ready to use.
Check the flashgun status with the Ready light and start shooting.
The green ready light C will reappear as soon as the lower temperature has been reached.
Make sure that no lights are on or blinking except the Ready light, which should be on.
If the Ready light changed from green to red while your computer was running, the computer could have become unresponsive.
When the printer is in the Ready state, press andhold the GO button until the Ready light starts blinking.
After a few seconds the green Steam Ready light will illuminate indicating the cleaner is ready for use.
A red Ready light indicates that your interactive whiteboard is receiving power but isn't communicating successfully with your computer.
Turn the temperature dial to„Sandwich Press“ andpre-heat until the green Ready Light(Fig. 1/ G) will illuminate.
If the Ready light changes from green to red while your computer is running, the computer can become unresponsive.
For approximately two minutes, the control panel lights flash in sequence, and then the green Ready light turns on.
Before you start troubleshooting,see page 20 to locate the Ready light, and then familiarize yourself with its states during normal operation.
If the indicator's behavior doesn't match a state listed here,refer to Troubleshooting Using the Ready Light starting on page 41.
Refer to this table for troubleshooting tips if the Ready light indicates that your interactive whiteboard is working properly, but you're still experiencing problems.
Located at the pen tray's left side, the Power panel has Power, Orientation and Help buttons, andthe interactive whiteboard's Ready light.
Try the troubleshooting tips in this table if the Ready light indicates that your interactive whiteboard is operating normally, but you're still encountering problems.
Product overview(Fig. 1) 1 ECO button with light 2 On/off button with power-on light 3 EASY DE-CALC light 4 EASY DE-CALC knob 5 Steam hose storage compartment 6 Carry lock release button(specific types only)7 Steam trigger/Steam boost(specific types only) 8 Iron ready light/Water tank empty light. .