Examples of using Pre-filter in English and their translations into Czech
{-}
-
Colloquial
-
Official
Dry the pre-filter after cleaning.
Dismantle the paper filter insert and the foam pre-filter.
Vacuum pre-filter for suction air.
Coverage Area 40 -50 m2 Weight 5.9k Filtration System Pre-filter.
Snap the pre-filter holder on the filter or.
Possible causes: No pressure in the untreated water, the pre-filter is blocked.
Press the pre-filter holder onto the combined filter.
Voluminous air filter with self-cleaning feature that when combined with optional cyclone pre-filter.
Press the pre-filter holder onto the particle filter.
You can only remove the gas filter after you have removed the particle filter.& 24; To remove the pre-filter, slide it out of the appliance Fig. 19.
Fit a pre-filter into the pre-filter holder. Fig. 21.
Self-cleaning air filters andoptional cyclone pre-filter Long machine service life and good life cycle costs.
If the pre-filter is damaged, worn or broken, do not use.
Therefore you have to descale the humidification filter when the filter light/ flashes See the chapter"Clean the pre-filter and descale the humidification filter.
Fit one pre-filter into the pre-filter holder. Fig. 21.
Pre-filter is designed to be mounted directly on the neck of the bottle.
Use 40x40 micron screen Pre-filter for removing particles from the water.
The pre-filter holder protects the main filter against handling damage.
An optional zyclone pre-filter is available on ATR 60 and ATR 68 machines.
The pre-filter is attached to the HEPA filter(1) by means of a Velcro fastener.
If you have cleaned the pre-filter in water, properly dry it before you place it back into the.
The pre-filter(foam filter) must be cleaned/ replaced after 25 hours of operation.
Optimize protocol handling, pre-filter CAN messages directly on the interface, or simulate missing hardware.
The pre-filter may be clogged. Clean the pre-filter see chapter‘Cleaning and maintenance.
This cleaner is also equipped with pre-filter, electrostatic main filter and active carbon filter to eliminate odors.
If the pre-filter is very dirty, use a soft brush to brush away the dust fig‚.
When the pre-filter is dry, reinstall the filter in reverse order.
Change the pre-filter once a year or every 25 hours of operation.
Use the pre-filter(15) when vacuuming fine, cold ashes or dust in order to.
Clean the pre-filter( 15) and if required, the folder filter( 13) see“Cleaning/Maintenance”.