Examples of using Arduino uno in English and their translations into Greek
{-}
-
Colloquial
-
Official
-
Medicine
-
Ecclesiastic
-
Financial
-
Official/political
-
Computer
What eat Arduino Uno.
Arduino UNO can drive max. 12 servo motors.
Starting With Arduino Uno.
The Arduino UNO™ is equipped with 6 analog inputs.
Getting Started with Arduino UNO.
The Arduino Uno is a microcontroller board based on the ATmega328.
You should start with Arduino Uno.
The GY-521 connected to an Arduino UNO.
The Arduino Uno is a microcontroller board based on the ATmega328.
LCD connection to Arduino Uno.
The Arduino Uno is a microcontroller board based on the ATmega328.
Fully compatible with the Arduino UNO R3 interface.
The traffic signal controller is implemented using Arduino UNO.
Works with Arduino UNO, Duemilanove, Diecimila, Leonardo or ADK/Mega R3 or higher.
The R3 is the third, and latest,revision of the Arduino Uno.
Spark comes with an Arduino UNO, preloaded with the latest GRBL firmware, and TB6600 Stepper Drivers as a controller.
In this tutorial you will learn how to use this sensor with Arduino uno.
The Rabbit Mill v3.0 comes with an Arduino UNO and a GRBL Shield with DRV8825 Stepper Drivers as a controller.
In addition, the start-up kit WIZFI250-EVB is compatible with Arduino UNO(WiFi Shield).
Finally, the Arduino Uno was upgraded to an Arduino Mega ADK and was moved inside the control box.
In this tutorial you will learn how to use a photoresistor with and without arduino uno.
Micro Mill comes with Arduino UNO and GRBL for controller while the stepper motors are controlled by Toshiba's driver.
In this tutorial you will learn how to use one 7 Segment Display with Arduino uno.
The Arduino Uno WiFi is functionally the same as the Arduino Uno Rev3, but with the addition of WiFi and some other enhancements.
In this tutorial you will learn how to use the raindrops sensor module with Arduino uno.
Connect your circuit with TTL to USB module(or Arduino uno board- note- remove ATmega328) with 5 cables to the programming header.
In this tutorial you will learn how to use LCD 16×2 display(and 20×4)with Arduino uno.
In this tutorial you will learn how to use this sensor with the Arduino uno and print the distance from an object to the serial monitor.
The Atmega328 on the Arduino Uno comes preburned with a Bootloader that allows you to upload new code to it without the use of an external hardware programmer.