低频 英语是什么意思 - 英语翻译

• low frequency
• low-frequency
• low frequencies
• lower frequency

在 中文 中使用 低频 的示例及其翻译为 英语

低频阵列（lofar.
The Low Frequency Array LOFAR.

一、测试低频的质量.
Test the quality of the low frequency.

好吧，让我们现在付出一些注意的低频。
Okay, let's pay some attention to the low frequency now.

因此，低频和中频技术更适合。
Low- and mid-frequency technology is therefore more suitable.

而图像的能量通常集中在低频部分。
Image energy is mainly concentrated in the low frequency part.

因此，开放匹配必须为低频提供更多的增益。
Therefore, open matching must provide more gain for low frequency.

ULF-ELF-VLF：超低频、极低频和甚低频网.
ULF-ELF-VLF: Ultra-low, extremely low and very low frequency network.

高频部分与低频部分分开；.
The high frequency part is separated from the low frequency part;

又因是低频，无需考虑Q值问题。
Because of the low frequency, there is no need to consider the Q value.

总体低频和RSR在水獭或鹅的尺寸上不存在。
Overall low frequencies and RSR has no presence on the otter or goose dimensions.

低频通常被用于清洗较小、较精密的零件，或清除微小颗粒。
Low frequencies are often used to clean smaller, more delicate parts or to remove tiny particles.

课程3：低频阻抗测量--我们能从电池获得什么信息？?
Battery EIS Tutorial Course 3/4: Lower Frequency Impedance Measurements- What Information Can we Get on a Battery?

低频和高频的频率划分与3MHz基本一致。
The frequency division of low frequency and high frequency and radio waves is basically consistent with 3MHz.

我们发现的300多个罕见和低频的差异，有74个似乎影响着蛋白质的结构。
Of the more than 300 rare and low frequency difference we found, 74 appear to affect the structure of proteins.

低频效果(LFE)声道提供低沉、强劲的低音效果，既可以感受到，也可以听到。
The Low-Frequency Effects(LFE) channel delivers deep, powerful bass effects that can be felt as well as heard.

当厚度大于1m时，低频125Hz的吸声系数接近1。
When the thickness is more than 1 m, the sound absorption coefficient of the low frequency 125 Hz will also be close to 1.

低频射频识别系统（30kHz到500kHz）只有很短的传播范围（一般小于6英尺）。
Low-frequency RFID systems(30 KHz to 500 KHz) have short transmission ranges that is usually less than six feet.

当厚度大于1m时，低频125Hz的吸声系数接近于1。
When the thickness is more than 1 m, the sound absorption coefficient of the low frequency 125 Hz will also be close to 1.

通常高频信号高于30MHz,但低频信号也受芯片珠的影响。
Usually the high frequency signal is above 30 MHz, however, the low frequency signal is also affected by the chip bead.

通常情况下，低频晶体为32.768KHz，因为这可以很好地解析实时时钟的精确滴答。
Typically, the low frequency crystal is 32.768 KHz since this resolves nicely to exact ticks that real time clocks like.

疲劳和恶心通常是由低频振动引起的，而高频可能会导致疼痛和听力下降。
Fatigue and nausea are often caused by low-frequency vibration, while high frequencies are likely to result in pain and hearing loss.

低频信号可以被释放，避免振动和闷热，最重要的是，它还可以补偿听力损失。
Low frequency signals can be released, avoiding vibration and stuffiness, and most importantly, it also compensates for hearing loss.

该频段电子标签工作在低频，最常用的工作频率为125kHz和135kHz。
The band's electronic tags operate at low frequencies, with the most common operating frequencies being 125 kHz and 135 kHz.

第三，低频发送能量，增加天线和接收器的尺寸，但需减小能量的密集度。
Third, sending the energy on a lower frequency increases the size of the antenna and receiver, but decreases the concentration of power.

另外，由于波长较小，mmWave比长波（低频）信号会经历更高的大气衰减。
Furthermore, due to its small wavelength, mmWave experiences higher atmospheric attenuation than longer-wavelength(lower frequency) signals.

欧洲低频阵列（lofar）项目的目标是更进一步，绘制信号图，看看它在天空中的变化。
The European Low-Frequency Array(LOFAR) project aims to go one step further and map the signal to see how it varies across the sky.

通常高频信号为30MHz以上,然而,低频信号也会受到片式磁珠的影响。
Usually the high frequency signal is above 30MHz, however, the low frequency signal will also be affected by the patch magnetic beads.

这LOFAR调查的灵敏度和分辨率在低频无与伦比，并且所需的技术进步使这成为可能都比较近。
The sensitivity and resolution of this LOFAR survey is unparalleled at low frequencies, and the technological advancements required to make this possible are relatively recent.”.

他主要的研究兴趣是硅技术，器件物理，低频噪音现象，辐射效应，缺陷工程和材料特质。
His main interests are silicon technology, device physics, low-frequency noise phenomena, radiation effects, defect engineering and material characterization.

混合接地使用电抗性器件使接地系统在低频和高频时呈现不同的特性，这在宽带敏感电路中是必要的。
Hybrid grounding makes the grounding system exhibit different characteristics at low frequencies and high frequencies, which is necessary in wideband sensitive circuits.