反应温度 英语是什么意思 - 英语翻译

• reaction temperature
• reaction temperatures

在 中文 中使用 反应温度 的示例及其翻译为 英语

此为放热反应，温度上升至1,700°C。
The reactions are exothermic, so the temperature increases to 1,700 °C.

而反应温度超过500摄氏度会导致腐蚀问题。
Reaction temperatures above 500oC cause corrosion problems.

反应温度控制在230-240℃。
The reaction temperature is controlled at 230-240℃.

由于是高度选择性的反应，反应温度不应超过60℃。
For highly selective reactions, a reaction temperature of 60 °C should not be exceeded.

启动PS4序列并监测反应温度。
Start the PS4 sequence and monitor the reaction temperature.

温度探头：深入反应釜体内部，实时监测反应温度.
SLP temperature probe: deep inside the reactor body, real-time monitoring of reaction temperature.

反应温度不仅决定反应物的反应速度，而且决定催化剂的反应活性。
The reaction temperature not only determines the reaction rate of the reactants, but also determines the reactivity of the catalyst.

生产工艺要求反应温度为-50℃，因此深冷机组完全能满足工艺要求的大规模降温要求。
The production process requires a reaction temperature of -50° C, so the cryogenic unit can fully meet the large-scale cooling requirements of the process requirements.

在进行本发明的异构化时，反应温度可在相当宽的范围内变动。
When carrying out the process according to the invention, the reaction temperatures can be varied within a relatively wide range.

而酸催化水合虽然不需要压力设备，反应温度也较低，但从产品中除去硫酸是相当麻烦的。
While acid-catalyzed hydration does not require pressure equipment and the reaction temperature is low, it is quite troublesome to remove sulfuric acid from the product.

化学家有时需要进行实验室实验，或修改试剂浓度和反应温度等变化。
The chemists sometimes need to perform lab experiments or tinker with reagent concentrations and reaction temperatures, among other changes.

对于液相反应，反应温度可为80℃到300℃，并且反应压力为约72psig到1300psig。
For liquid phase reactions, the reaction temperature may be from about 100° C. to 300° C., and the reaction pressure from about 72 psig to 1300 psig.

化学家有时需要执行实验室实验或与试剂浓度和反应温度，其他的变化中修补。
The chemists sometimes need to perform lab experiments or tinker with reagent concentrations and reaction temperatures, among other changes.

本品在酸性反应温度达80℃时开始溶解，但不影响产品品质。
This product will dissolve in organic acid when the reaction temperature reaches 80 °C, but it will not affect the product quality.

这是由一个起始反应温度低达470ķ证明，而最低的共晶温度在该系统中发生在910K表;
This is evidenced by an onset reaction temperature as low as 470 K, whereas the lowest eutectic temperature in this system occurs at 910 K;

反应温度在700℃-850℃之间时，二恶英产生的浓度最大。
When the reaction temperature is between 700° C and 850° C, the concentration of dioxin is the highest.

举例来说，维持原料的一部分为液相所需要最小压力将可能随反应温度变化。
For instance, the minimum pressure required to maintain a portion of the feedstock in the liquid phase will likely vary with the reaction temperature.

同时，Fe2+还会引起物料温度急剧升高，难于控制环氧化反应温度。
At the same time, the fe2+ also causes the material temperature to rise sharply, difficult to control the epoxidation reaction temperature.

溶液的组成，反应温度和确定蓝色的时间取决于钢基材的组成。
The composition of the solution, the reaction temperature and the time when the blue color is determined depends on the composition of the steel substrate.

有数家公司曾尝试开发乙烷法工艺，但要开发出反应温度低于500摄氏度的工艺一直是个挑战（cheresources.com，2008年）。
A number of companies have attempted to develop an ethane-based process but development of a process with reaction temperatures below 500oC has been a challenge.(cheresources. com, 2008).

合适的反应温度可以是室温(25℃-30℃)。
The suitable temperature of the reaction may be room temperature(25-30° C.).

主要缺点是需要较高的反应温度。
The primary disadvantage is that high reaction temperatures are needed.

在使用石腊油作为反应溶剂时，反应温度可高达260℃。
Reaction temperature can be increased to 260°C when paraffin oil is used as reaction solvent.

在自热过程中，反应温度通过其自身的热释放来维持。
In autothermal processes, the reaction temperature is maintained by its own thermal release.

在自热过程中，反应温度通过其自身的热释放来维持。
In autothermal processes, reaction temperature is maintained due to own thermal release.

在实际生产过程中，控制反应温度恒定、不波动也很关键。
In the actual production process, it is also critical to control the reaction temperature to be constant and not to fluctuate.

为了获得不同的反应温度，需要使用真空来降低反应混合物的沸点。
In order to obtain different reaction temperature, vacuum is needed to reduce the boiling point of reaction mixture.

为了获得不同的反应温度，需要使用真空来降低反应混合物的沸点。
In order to achieve different reaction temperatures, the boiling point of the reaction mixture is lowered using vacuum.

但市场上的主要厂家都放弃了车载重整的思路，因为太不切实际（重整反应温度过高，见上文）。
However the major market players discarded the approach of on-board reforming as impractical.[citation needed](At high temperatures see above).

AlfredPongratz和JuliusvonBraun分别对反应作了一些改进，将反应温度提高，并使反应在无溶剂条件下进行。
Independently Alfred Pongratz and Julius von Braun improved the reaction by changing the reaction conditions to higher temperatures and used no solvent for the reaction..