夹角 英语是什么意思 - 英语翻译

• angle

在 中文 中使用 夹角 的示例及其翻译为 英语

每个夹角都应.
Every brand should.

为F与v之间的夹角。
Angle between u and v.

升交点至近地点夹角：.
Ascending node to perigee angle:.

两轴之间的夹角还可以改变。
Effects between two frames can also be changed.

其主轴夹角必须是准确的90度。
The right angle needs to be an accurate 90 degrees.

知三边；另一类是已知两边及其夹角.
The remaining sides of a triangle, knowing two angles and one side.

三组解理完全，夹角等于或近于90。
Three groups of cleavage complete, the angle is equal to or near 90°.

整个系统布置在V型发动机的V型夹角内侧。
The whole system is arranged on the inside of V type V type angle engine.

动力水管与水平面夹角（最优）大约(7~10)度.
Angle between drive pipe and ground(The best) About 7~ 10 degrees.

但是，我们没有理由强迫他们掌握向量夹角和非连续函数。
But there is no reason to force them to grasp vectorial angles and discontinuous functions.

三组解理完全，夹角等于或近于90°。
The three sets of cleavage are complete and the angle is equal to or close to 90°.

裂纹的方向和焊缝平行，和钢管轴线成夹角，一般在30~70°之间。
The direction of cracks and weld parallel, and the steel pipe into an angle, usually between 30-70°.

但无论采用哪种刀法,都必须顶刀切,且刀与原料要呈90°夹角。
But no matter what kind of knife, must be the top knife cut, and the knife and raw materials to be 90° angle.

裂纹的方向和焊缝平行，和钢管轴线成一定夹角，一般在30-70°之间。
The direction of cracks and weld parallel, and the steel pipe into an angle, usually between 30-70°.

多自由度运动，每个运动自由度之间的空间夹角为直角。
Multi-degrees of freedom movement, the angle of space between each degree of freedom of movement is a right angle.

裂纹的方向和焊缝平行，和钢管轴线成一定夹角，一般在30杠70°之间。
The direction of cracks and weld parallel, and the steel pipe into an angle, usually between 30-70°.

传动轴的长度和夹角及它们的变化范围由汽车总布置设计决定。
The length and angle of the drive shaft and their range of variation are determined by the overall layout of the car.

新型V12发动机除了保留传统的60度汽缸夹角外，与其前身无任何相同之处。
New V12 engine in addition to traditional 60 degree cylinder angle, but its predecessor no similarities.

有两组完全解理,其夹角90°单斜晶系）或近于90°(87°）（三斜晶系)。
Have two sets of complete cleavage, its Angle of 90°(monoclinic system) or close to 90°, 87°(triclinic crystal system).

单面梯与地面夹角以60-70度为宜，梯下应有专人监护，禁止二人同时在梯上作业。
Single-sided ladder and the ground angle of 60°~ 70° is appropriate, prohibit two people at the same time on the ladder operation.

如因地形条件限制不能垂直安装，则水管轴线与水平面夹角应在60°以上。
If because of the terrain conditions, it cannot be installed vertically, the pipe axis and horizontal plane angle should be in more than 60°.

单面梯与地面夹角以60-70度为宜，禁止两人同时在梯上作业。
Single-sided ladder and the ground angle of 60°~ 70° is appropriate, prohibit two people at the same time on the ladder operation.

然而在测量之后，研究人员却意外地发现，有的粒子对的轨迹夹角为115º。
When the researchers made this measurement, they found an unexpected excess of pairs of particles with an angle between their trajectories of 115º.

单向梯与地面夹角以60-70度为宜，禁止两人同时在梯上作业。
Single-sided ladder and the ground angle of 60°~ 70° is appropriate, prohibit two people at the same time on the ladder operation.

Kosmos1870-在1987年七月25日，第二艘Almaz-T卫星顺利发射升空并入轨，轨道夹角为71.92度。
Kosmos 1870- On July 25, 1987, Almaz-T2, the second Almaz-T spacecraft, successfully reached orbit with an inclination 71.92 degrees toward the Equator and it was officially identified as Kosmos-1870.

单面梯与地面夹角以60&-70&为宜，禁止二人同时在梯上作业。
Single-sided ladder and the ground angle of 60°~ 70° is appropriate, prohibit two people at the same time on the ladder operation.