What is the translation of " 信号强度 " in English?

• signal strength
• signal intensity

Examples of using 信号强度 in Chinese and their translations into English

信号强度为166-DBM左右，属于比较弱的信号。
The signal strength is -166dbm, which is a weak signal..

如果天气状况较差，信号强度可能会受影响。
If the weather conditions are bad, the signal strength may be affected.

信号强度为-166dBW左右，属于比较弱的信号。
The signal strength is -166dbm, which is a weak signal..

信号强度与当前BSSID的RSSI的差异.
The difference in signal strength against the current BSSID's RSSI.

如果天气状况较差，信号强度可能会受到影响。
If the weather conditions are bad, the signal strength may be affected.

我的应用程序到14酒吧共区分的信号强度。
In my app I differentiate the signal strength in total 14 bars.

我的应用程序到14酒吧共区分的信号强度。
My app differentiates the signal strength into a total of 14 bars.

在那里您可以看到信号强度。
Where do you see the strength signs.

另外，如果您认为信号强度指示符（条形）不必要或多余，则可以选择在使用显示模式时将其隐藏。
Also, if you consider the signal strength indicator(aka the bars) unnecessary or redundant, you can choose to hide it when using a display pattern.

一边看像素值的直方图，调整积分时间，直到信号强度电平是最大计数的约75％。
While watching the histogram of pixel values, adjust the integration time until the signal intensity level is approximately 75% of the maximum counts.

展示无线网络连接的重要信息（外部IP，信号强度，下载与上传速度，子网掩码，网关和DNS）.
Shows information about the wifi connection(external IP, signal strength, download and upload speed, subnetmask, gateway, DNS).

对于信号强度，它显示负dBm值;对于百分比，它显示接收到的最后一个信号的值和平均值。
For the signal strength, it shows negative dBm values and for percentages, it shows values for the last signal received and the average over time.

如在焦磷酸测序方法中，如果被加入相同的核苷酸的一个以上，在pH值/信号强度的变化是相应较大。
As in the pyrosequencing method, if more than one of the same nucleotide is added, the change in pH/signal intensity is correspondingly larger.

重建图像和分析数据的时间积分的挑选是脱机根据信号强度。
Time integrals for reconstructing images and analysis of the data were selected offline according to the signal intensity.

建立网络的SSID，信号强度和安全协议后，恶意软件会尝试连接到该网络。
After it establishes a network's SSID, signal strength, and security protocol, the malware tries to connect to it.

除了的更复杂的图形表示形式的信号强度你还能够看到一些更有趣的信息。
In addition to the more sophisticated graphical representation of the signal strength you will also be able to see some more interesting information.

MRI分析显示，在结肠小鼠中T2信号强度比增加约两倍。
MRI analysis showed an approximately two-fold increase in the T2 signal intensity ratio in colitic mice.

高达90％的信号强度可能会以这种方式丢失，从而影响测量的准确性和可靠性。
Up to 90 percent of the signal strength can be lost this way, affecting the accuracy and reliability of measurements.

使用以下方法确定Wi-Fi连接的信号强度，并找到改善所连接设备的Wi-Fi范围的方法。
Use the following methods to determine the signal strength of your Wi-Fi connection and find ways to improve the Wi-Fi range of your connected devices.

详细的评估报告还会列出可能存在的干扰源、建议的设备类型、设备位置、预计覆盖范围和实测信号强度。
A detailed assessment report also identifies existing sources of possible interference, proposed equipment type, device locations, expected coverage areas, and surveyed signal strength.

InSSIDerWi-Fi扫描器可以执行各种任务，包括查找开放的Wi-Fi接入点，跟踪信号强度，并使用GPS记录保存日志。
The inSSIDer Wi-Fi scanner can do various tasks, including finding open Wi-Fi access points, tracking signal strength, and saving logs with GPS records.

高频器件的短波长意味着信号反射将被小的表面运动散射，导致返回信号强度的损失。
The short wavelength of high-frequency devices means that the signal reflection will be scattered by small surface movements, causing loss of returning signal strength.

神经元可以具有状态(0到1之间的值)和随着网络学习而增加或减小信号强度的权重。
A neuron can have state(a value between 0 and 1) and a weight that can increase or decrease the signal strength as the network learns.

InSSIDerWi-Fi扫描仪可以执行各种任务，包括查找开放式Wi-Fi接入点，跟踪信号强度以及使用GPS记录保存日志。
The inSSIDer Wi-Fi scanner can do various tasks, including finding open Wi-Fi access points, tracking signal strength, and saving logs with GPS records.

如果没有很好地绝缘，信号传输速率将减慢，并且信号强度将受到严重降低。
If it is not well insulated, the signal transmission rate will slow down and the signal strength will be severely reduced.

这些应用程序根据从零到100％的百分比以及专门针对硬件量身定制的其他细节来报告信号强度和质量。
These applications report signal strength and quality based on a percentage from zero to 100% and additional detail tailored specifically to the hardware.

例如，设备型号、操作系统版本、唯一设备标识符、电池、信号强度等信息;
For example, device model, operating system version, unique device identifier, battery, signal strength, and so on.

本月早些时候，苹果公司承认它使用了错误的公式来计算所有手机的信号强度。
Earlier this month, Apple conceded that it had used the wrong formula to calculate signal strength for all its phones.

电池的实际寿命可以根据网络连接、组件、设置、信号强度、噪声和其他许多因素而发生变化。
The actual time of battery life may vary depending on the network connection, component, setting, signal strength, noise and many other elements.

Wl2:范围内所有无线网络列表以及它们的MAC地址和信号强度。
Wl2: list of all in-range wireless networks and their MAC addresses and signal strengths.