設定圧力 Meaning in English - translations and usage examples

set pressure
設定圧力
セット圧力
設定圧
setting pressure
設定圧力
セット圧力
設定圧

Examples of using 設定圧力 in Japanese and their translations into English

{-}
  • Colloquial category close
  • Ecclesiastic category close
  • Computer category close
  • Programming category close
設定圧力近傍までプロセスガスが漏れない。
Process gas does not leak to near the set pressure.
設定圧力に達すると、インフレータが自動的に閉じます。
When the set pressure is reached, the inflator automatically closes.
型式ディスク材質設定圧力範囲出口部。
Type Disk packing materials Set pressure range Outlet.
設定圧力範囲/。
Setting pressure range/.
小さい流れによって、設定圧力は不安定かもしれません。
With a small flow, the setting pressure may be unstable.
LCCM弁設定圧力
Setting pressure for ICCM valve.
設定圧力(例)。
Example for setting pressure.
設定圧力に達したとき、マイクロスイッチを動作させ警報や制御に用います。
When it reaches the set pressure, the microswitch is used to operate and to warn and to control.
設定圧力に達した時、マイクロスイッチを作動させ警報や制御に用います。
When set pressure is reached, it activates switch to use for alarm or control.
設定圧力に達した時、マイクロスイッチを作動させ警報や制御に用います。
When it reaches setting Pressure, the microswitch is used to operate and to warn and to control.
ページ1319.フロントパネルにある圧力計の目盛が工場出荷時の設定圧力まで徐々に上昇します。
Page 13 19. The pressure gauges on the frontpanel will gradually increase to the factory set pressure.
一次側圧力:14.7MPa/二次側設定圧力:0.1MPa。
Primary side pressure: 14.7MPa/ secondary side setting pressure: 0.1MPa.
再度、圧力計の目盛が工場出荷時の設定圧力まで徐々に上昇します。
The pressure gaugeswill again gradually increase to the factory set pressure.
圧力計指針に接点が付いていますので、圧力指示値と接点設定圧力とが正確に作動します。
Pressure pointer provided with contact,ensuring accurate pressure indication and pressure setting.
調整前の低気圧の設定で、必ず確認してください高圧力が設定圧力ゲージをこれ以上の低気圧に設定す!
Before adjusting the low pressure setting,always check the high pressure setting with a pressure gauge to ensure that it lies above the low pressure setting!
過熱器用の安全弁の設定圧力は、ドラム用の安全弁に比べて低く、リフティング空気がオンの状態で作動しています(接続形態N、3ページのタイプコードを参照ください)。
The set pressure of the superheater safety valve is lower compared to the drum safety valve and is in operation with lifting air on(connection mode N, see type code page 3).
給油管L1の端部はリターンポートR1に接続され、端部の圧力が設定圧力を超えると、パイロットスプールが右室に押し込まれます。
The end of the oil supply pipe L1 is connected to the return port R1,and when the pressure at the end exceeds the presetting pressure, the pilot spool is pushed to the right chamber.
開閉ヒステリシスの低減、バルブのブローオフ機能の安定化、設定圧力下での制御安全弁の開弁、圧力保持によるオーバーフロー制御などの動特性が向上し、運転効率が向上、かつ、ダウンタイムが減少。
Improvement of the dynamic performance, e.g. reduction of the opening and reseating hysteresis, stabilisation of the valve blow-o,controlled safety valve opening below the set pressure, controlled overflow with pressure maintenance improving operating efficiency and reducing down time.
潤滑装置安全弁AF系は、濃縮オイル潤滑システムに適しており、通常のレベルでシステム圧力を維持するために使用され、メディアグレードN22-N460の粘度に適用可能な設定圧力を超えません。
Lubrication equipment safety valves AF series is suitable for concentrated oil lubrication system, used to keep the system pressure in the normal level anddoes not exceed the set pressure, applicable to the viscosity of the media grade N22-N460.
油圧切換弁(1a)は2本の供給主管を交互に切換える機能を持ち、ポンプ吐出圧力が設定圧力に達すると、油圧切換弁(1a)が切換って信号を電気制御盤④に送り、ポンプ①を停止させます。
The hydraulic operating valve(1a) functions to alternately switch the two main supply lines.When the pump discharge pressure reaches the preset pressure, the hydraulic operating valve(1a) is switched to send a signal to the electric control panel(4) to stop the pump(1).
設定圧力の高い設定精度(<99%)。
High setting accuracy of set pressure(<99%).
取扱い・保守・品質保証について法令及び規格の設定圧力
About handling, maintenance, and QA Laws and Regulations, and specified pressure.
BRチャックに交換する際のシリンダの設定圧力についての注意事項。
Precaution for cylinder set pressure when replacing a chuck with BR chuck.
差圧スイッチ/圧力制御弁の標準設定圧力は約5MPaです。
The standard setting pressure of the differential pressure switch/ pressure control valve is about 5MPa.
このバルブは、設定圧力値に達すると低圧ポンプをアンロードに切り換えます。
It switches the low-pressure pump to unpressurised circulation if the pressure value set is reached.
流体の圧力を検知し、設定圧力になると電気的な信号を発信する機器です。
A device that detects fluid pressure andmakes electrical contact when a certain set pressure has been reached.
ラプチャーディスクに対して、同じ設定圧力を使用して、工程をより高い圧力にすることができます。
You can work the process to a higher pressure using the same set pressure for the rupture disc.
圧力変動がある回路の場合は、回路の設定圧力ではなく圧力変動のピーク圧力となります。
The piping circuits with pressure fluctuations are set at the peak pressure of the pressure fluctuations and not the setting pressure of the piping circuit.
ドーム圧力の降下を感知したパイロット・レギュレーターが開いてドームにガスを追加供給することで、本来の設定圧力を維持します。
The pilot regulator senses the drop in dome pressure and responds by opening to allow additional gas into the dome andmaintaining the intended set pressure.
による検討の互換性シール材は+70°Cその後の圧力調整なく、その後の設定圧力の調整なしチェックの圧力を圧力ゲージに!
By consideration of the compatibility with seal material not over +70°C. Subsequentpressure adjustmentDo not a make any subsequent pressure settings of adjustments without checking the pressure with a pressure gauge!
Results: 402, Time: 0.0305

How to use "設定圧力" in a sentence

設定圧力 付近ではゆっくりとしたモータ回転数で運転するので運転音が静 かです。
5 ろ過精度 設定圧力 0.
空気を安定した圧力に調整します 設定圧力 MPA 0.
4KG仕様 ろ過精度 使用圧力 処理空気流量 立米 MIN 接続口径 設定圧力 0.
圧縮空気を安定した圧力に調整 国内最小 圧力を操作出来ます 超小型ですのでエアーツールの手元で抜群の使いやすさです 小型でもしっかり圧力制御します リリーフ機構も装備してます 仕様 設定圧力 MPA 1.

Word-for-word translation

Top dictionary queries

Japanese - English