Примеры использования Gas cooler на Английском языке и их переводы на Русский язык
{-}
-
Official
-
Colloquial
Gas Cooler Series TC-MIDI.
The sample gas cooler in the PCS.
Gas Cooler Series TC-Mini.
Quick and accurate steps to a customised gas cooler.
Gas Cooler Series TC-Double.
Complete transformer substation of gas cooler.
Gas cooler performance levels.
Never operate the gas cooler outside the specifications.
Gas Cooler Series TC-Standard.
Installation and Operation Instructions Sample gas cooler EGK 2A Ex Introduction.
This gas cooler was designed specifically for use in explosive areas.
The basic version of this system consists of a gas cooler with condensate pump and a filter.
The sample gas cooler can be used as a stand-alone unit or wall mounted.
Two new possibilities of efficiency increase by moistening combined our gas cooler in completely new design.
Gas cooler models with two heat exchangers The item number is a code for the configuration of your unit.
This requires components such as gas cooler, gas pump, filter, condensate pump and flow meter.
Gas cooler model with two heat exchangers in series The item number is a code for the configuration of your unit.
The base version of the gas conditioning system consists of a gas cooler with condensate pump and a filter.
It is equipped with a gas cooler with a Danfoss variable frequency regulation system oper ating at -38 C/ +40 C.
The base version of the gas condition system consists of a gas cooler with condensate trap, a gas pump and filter.
The sample gas cooler is therefore a part of conditioning, which is illustrated as a typical flow chart below.
Depending on the composition of the sample gas, a pre-separator may also need to be installed upstream from the sample gas cooler.
A P1 gas pump can be attached to the gas cooler, optionally also with bypass valve for regulating the flow.
Gas Cooler Technical Data Ready for operation after max. 10 minutes Ambient temperature 5 C to 50 C Gas outlet dew temperature preset: adjustable.
The small dimensions make the TC-MINI sample gas cooler particularly suited for OEM's to build into compact sample gas conditioning systems.
The facilities include equipment like filter separators, gas dryer units,several compressor units(some of them electric), gas coolers and metering sections.
The sample gas cooler must be secured with suitable overload protection protective motor switch according to certification.
Sturdy dew point conditions inside the gas cooler are seen alongside against safe gas drying whilst utilising the maximum cooling capacity.
Gas cooler technical data Gas Cooler Technical Data Ready for operation after max. 10 minutes Ambient temperature 41 F to 122 F Gas outlet dew temperature preset: adjustable.
EGK 1/2 is a compressor sample gas cooler for up to 2 gas paths and is an essential component for sophisticated analysis systems.