Примеры использования Pwm на Английском языке и их переводы на Русский язык
{-}
-
Official
-
Colloquial
Solar charge controller pwm.
PWM Solar Charge Controller.
Peripherals: LVD, POR, PWM, WDT.
Setup PWM period, by changing value of PR2.
Peripherals: lcd, lvd,por, pwm, wdt.
You set the Slot for the Pwm Pin a zero to stop the Pwm.
LFO features a sine waveform with PWM.
FAST-output PWM with high-resolution DAC from firmware V 3.0 onwards.
Peripherals: Brown-out Detect/Reset,POR, PWM, WDT.
For PWM and Satellite connection- method 1.(requirement- 6ch radio).
Whatever the number of pins used as"Pwm", the repetition time is always 250 Hz.
Dimmers PWM outputs connected to LEDs showing the level of lighting dimmer.
The TTL level serial transceiver port RX/ TX 4.6 PWM ports, D3,, D5, D6, D9, D10, D11.
You can control the PWM Mosfet up to quite high frequencies, even hundreds of KHz.
For LED on and off, set their pins as DigOut,to adjust brightness, set as Pwm_16.
Theremino system modules generate Pwm signals from 0 to 4 mS. The repetition time is 4 mS.
In PWM control mode the battery allow user to adjust the desirable output power rate.
Directional Motor Control Use PWM and Inverted PWM to control speed and direction.
Recreating sine, triangular, rectangular,rectangular with PWM and sawtooth waveforms.
And always through the Pwm signal current can be adjusted from zero up to a painful milliampere current.
The oscillator generates triangle, square,and square with PWM, there's a sub oscillator included.
In this experiment I will try to investigate beatiful module which has name CCP Capture/Compare/Pwm.
Oscillators generate square,saw and PWM while sub oscillator offers 4 wave types.
It starts with a Pwm output of the Master and with a few instructions software you can get all the repetitions that you want from 1 Hz to 100 Hz and beyond.
It is used to multiply the outlets(Digout,Servos or Pwm), make sure that the outputs are not enabled you are flying.
In this circuit was added a resistor from 100 ohm and diminished the output capacitor to expedite your requests and to be able to fly with a Fast_Pwm output adjusted 15 KHz.
You set the PIN-out as Pwm_16 and, through a small converter, you get a signal from 0 to 5 Volts,"one volt per octave.
Servo signals vary from about 0.5 mS(minimum) about 2.5 mS(maximum) and the repetition time is approximately 16 mS. The accuracy of servo signals is consistent with any number of pins configured as"Servant" butdecreases if the same module are also used pin-type"Pwm.
You can use it to prove the Pwm outputs or PwmFast and to test applications that read the signal from the slots.
Adjusting the repetition in software 1 You set the Slot for the Pwm Pin number from 0 to 1000 which regulates the desired current.