Примеры использования The resistor на Английском языке и их переводы на Русский язык
{-}
-
Colloquial
-
Official
That is, cut off the resistor with the Clippers.
The resistor test can be performed in two modes.
Replace the resistor with a 100 k, to measure low level signals.
Name the wire between'MYCONN3' and the resistor as'INPUTtoR'.
Or, in place of the resistor, you could use a car headlight bulb.
Disassemble it, remove the circuit board,then scrub the resistor jumper connections.
ATTENTION: The resistor R6 serves as protection against short circuits.
From Ohm's law, the voltage difference across the resistor is therefore about 350 mV.
The resistor you previously chose is now in your history list, appearing as'R'.
A high voltage(11 kV) of negative polarity is supplied to them via the resistor R =20 МΩ.
Name the wire between the resistor and the LED as'LEDtoR'.
The resistor should be positioned near the ferrule, IE at the end of the shielded cable.
To avoid it you could replace the resistor R6 with one from 4.7 ohm resistor. .
But the resistor continues to heat up and you can't heal it, then all that remains is to operate.
The resistor R4 serves to prevent wrong scope,the second hand goes violently at full scale and ruin.
Bonehead manufacturer, because the shower has a camera that only closes the resistor circuit if water.
Schematic diagrams of the resistor voltage amplifier// Researches in Science.
In these pictures the transistor is a BC548,the diode a 1N4148 and the resistor is from 1 k 1/8 watt.
Returning all'example of the resistor that heats, a holistic practitioner would act so.
And it is also easily adaptable to any tension from 100 Volts up to 600 Volts(and beyond)changing the value of the resistor R8.
With this change in case of short circuits the resistor would burn, you will then need to consider a fuse.
The resistor should be positioned close to the input pins to minimize noise collected from reading wire.
Annotation: In this work, optimization of the parameters of the resistor mathematical model using evolutionary strategy has been performed.
Sure that the resistor must be COMPLETELY INSIDE the inner Chamber, otherwise collects complaints and does not work anymore.
In general you should delete the capacitors in series(cortocircuitarli with a drop of Tin)and remove the resistor designed for powering electret microphones.
The resistor in parallel, being of high strength, dissipates shortly and then it can be a normal resistor from 1/4 Watts.
In series with the protective gap to protect the resistor, the resistance is usually taken as 1Ω/ V, the resistor length is also selected by table.