Примеры использования Wireless receiver на Английском языке и их переводы на Русский язык
{-}
-
Colloquial
-
Official
It's a wireless receiver.
Easy to install andspace-saving inside control cabinets/ New wireless receiver.
Wireless receiver module.
Inch Portable HD Wireless Receiver COFDM.
Wireless receivers with gateway».
Plug the pad or wireless receiver back in.
Wireless receiver for garage door.
Connection Type Wired Thermostat Wireless-Receiver Wired.
WR-1 wireless receiver with¼" jack.
Home Receiver& Control board wireless receiver for garage door.
Wireless receiver for medical applications.
The plugs on the power adaptor and wireless receiver are disconnect devices and will remain.
Wireless receiver 2.4 GHz with 6 channels for 24 actuators.
Unplug the gamepad(or wireless receiver, if the gamepad is wireless). .
Wireless receiver Garage receiver kit remote controller.
The SlimPAR T6 USB is able to become a D-Fi wireless receiver/transmitter with the use of the D-Fi USB from CHAUVET DJ.
The wireless receiver is a Class I device and must be connected to a mains socket with a.
To use the dawn simulator and to control your lamp from your SoundSpa Sunrise, plug your lamp into the wireless receiver Fig. 3.
WR-1 wireless receiver with¼" connector.
Use a standard USB extension cable orUSB hub to increase the space between your wireless receiver and the USB3.0 connection port.
WR-1 wireless receiver with 2-pin AT connector.
To use the dawn simulator and to control your lamp from your SoundSpa Sunrise, plug your lamp into the wireless receiver Fig. 3.
Then plug the wireless receiver into a 230V household outlet.
This set contains 2 parts: RF-8T: a small, wireless remote with 15 buttons- RF-8R: wireless receiver with 3pin XLR DMX-output.
Remove the wireless receiver, and connect it back to the computer.
The steute business division Wireless will be using the Hannover Fair as a launching pad for its new generation of wireless receiver units series RF Rx SW868/915.
There is a wireless receiver meter, the test bench does not receive directly.
In practice, the wireless position sensors available for different frequencies(868, 915 and 922 MHz) are predominantly used to monitor the occupancy of roller conveyors in rack systems: when the last container is removed,the sensor transmits a signal to the wireless receiver and requests replenishment.
The wireless receiver has a balanced XLR output for each wireless transmitter, and also a unbalanced MIX output on a 6.3mm Jack plug.
Our engineers have developed a new housing concept which enables wireless receiver units with one, two or four relay outputs to be integrated in very compact housings.