Примери за използване на Be filled with water на Английски и техните преводи на Български
{-}
-
Colloquial
-
Official
-
Medicine
-
Ecclesiastic
-
Ecclesiastic
-
Computer
Base can be filled with water.
The lower part of the cleaner will be filled with water.
Can be filled with water or sand.
Rd of the stove has to be filled with water.
It must be filled with water or sand.
Before working surface pump must be filled with water.
Can be filled with water or sand for increased stability.
Why must a self-priming pump first be filled with water?
It can be filled with water or sand to make it more stable.
Two water tight sections can be filled with water without the vessel.
Before the pump is operated for the first time,the tank should be filled with water.
Calderas may be filled with water, creating crater lakes.
During the initial start-up,the pump must first be filled with water.
It could be filled with water for sea battles.
Some portable basketball hoops have bases that have to be filled with water or by sand.
The Coliseum could be filled with water for naval battles.
Image caption Researchers replaced the concrete block(left)with a plastic container that can be filled with water(right).
Raw materials should be filled with water, and then placed on a water bath.
In order for the surfaces to fit tightly together,the bath can be filled with water for several hours.
Pit should be filled with water and wait until the moisture is absorbed.
To do this,crushed wood pulp should be filled with water and gently mixed.
For this is what the Lord says: You will see neither wind nor rain, yetthis valley will be filled with water.
Each May, the construction will be filled with water so that it can warm up till summer.
If a small reservoir placed in a plastic or some other form from which the fall of water discharged, in early May,after a thorough cleaning it can be filled with water.
Thus, the hydraulic level must be filled with water to zero, without the formation of bubbles.
The basin should be filled with water approximately 30-40 cm, then a concrete solution is poured into the formwork, the level of which must coincide with the water level in the pool.
To avoid possible problems,loss of fluid must be filled with water or an isotonic drink.
The hydro level must be filled with water, the liquid in the flasks should be at the middle mark.
They are usually equipped with traps that should be filled with water to prevent odours and sewer gas from escaping.
The fuel tank must be filled with water up to 90% of the mass of a full load of fuel as specified by the manufacturer with a± 1% tolerance.