Примери за използване на Mauerlat на Английски и техните преводи на Български
{-}
-
Colloquial
-
Official
-
Medicine
-
Ecclesiastic
-
Ecclesiastic
-
Computer
There are ways to fasten the Mauerlat.
Installation of mauerlat and support bars.
We note the junction of the rafters with mauerlat.
In the rafters at the joints with mauerlat cut down mounting slot;
On the mauerlat the sizes are calculated depending on the….
On the longitudinal walls laid mauerlat, beam at least 180 mm thick.
The upper part of the beam rests on skates,the lower- in the mauerlat.
Bearing rafters on the mauerlat: construction mounting technology.
An enlarged step of the anchors that attach the mauerlat to the walls;
The calculation of the mauerlat is not required in the following cases.
To do this, take the board,equal in length to the distance between mauerlat.
Prepared Mauerlat put on the bolts, put the washer and tighten the nut.
Well, the rafters are held on the beams of the Mauerlat according to the principle of the ram.
To install the Mauerlat studs, mark out and drill the holes for installation.
On the wall on the perimeter of the building laid mauerlat and fix them;
Fastening of the mauerlat to aerated concrete with wire, anchor bolts and studs.
Make cuttings in the joints of the rafters with mauerlat, we use pads, metal braces.
Mauerlat, laid on the perimeter, it is necessary to attach to the wall anchors.
The rafters are mounted on the Mauerlat and the logs of the last wall of the walls.
In the absence of spacer loads, the operating conditions of the mauerlat are as follows.
Therefore, the mauerlat is not calculated, but its section is designated constructively.
The square bar for this element has the same section as for the mauerlat- 10/10 or 15/15 centimeters.
To fix the Mauerlat, it is recommended to install the embedded elements and armo-belt.
Then the board is applied to the edge of the Mauerlat and drilled holes according to the markings.
Mauerlat is an important part of the roofing system, with a log or timber in its role.
For garage easiest option would be normalrafter roof,for which the device is mounted on the wall mauerlat of timber.
For the spacer system, the mauerlat must be very tightly attached to the wall of the house.
The outer protrusion of the wall dramatically increases the safety of operation,is an insurance against advances Mauerlat, truss system.
Mauerlat allows you to evenly distribute the load on the walls of the building.
The basis for the construction is the mauerlat- timber, attached along the perimeter of the walls by special reinforced anchors.