Примери за използване на Required distance на Английски и техните преводи на Български
{-}
-
Colloquial
-
Official
-
Medicine
-
Ecclesiastic
-
Ecclesiastic
-
Computer
Hence the required distance=.
Required distance to the drain.
Therefore the required distance.
The required distance between seedlings should be 3-5 meters.
As a result, the required distance.
Set the required distance and fix the screw again.
Maybe it just gives me the required distance.
Adhere to the required distance while driving.
This is followed by using stationery clips to attach them to the board- based on the required distance.
Follow the lane, and keep the required distance between vehicles.
Observe the required distance between the engine mass and the heated motor components;
First the meter is positioned at the required distance(in this example, 6 inches).
Infringements/Sanctions If, when a free kick is taken, an opponent is closer to the ball than the required distance.
Construct a jumper on the floor and ceiling at the required distance from the wall and attach.
Failure to respect the required distance when play is restarted by throw in, corner or free kick.
For spray application, see sections 4.4 and6.6 for specific recommendations on the required distance from tissue per surgical procedure.
For this, having retreated the required distance, an incision is made along the length of the clerical knife.
Each time for 5-10 seconds, fix your gaze on the object,forcing the accommodation unit to turn on at the required distance.
The device itself must be firmly fixed at the required distance from the surface of your table top.
A narrow bottle bottle that is pulled out on wheels is a great way to differentiate the refrigerator andthe cooking area from the required distance.
The duration of the races and the length of the required distance will be determined only by the doctor.
There are a wide variety of snakes, insects and others that could be dangerous for you if you are not very cautious anddo not follow the required distance.
With the help of a template, the required distance of the limiter is set when processing a flat file on its edges.
The final stage of the manufacture of simple device- mount racks,which are adjusted to the required distance between the floor and ceiling.
Failing to respect required distance when play is restarted with a corner kick, free kick or throw-in.
Therefore, to perform the task, the equipment is connected to the concrete pump,which allows pumping the solution with such fillers to the required distance.
From the nearest wall in several places,measure the required distance and draw a line on the floor and the ceiling.
The required distance of the limiter is controlled by a template that is installed between the surface of the limiter and the corresponding edge of the cutting tooth.
In all corners of the room with the help of the water levelmake a mark, with the required distance from the base of the ceiling, measure, focusing on the bottom corner of the room.
The end of the tape measure is positioned at the surface of the tube or face of the lamp, and the meter is positioned so thatthe sensor is at the required distance from the light.