Примери за използване на The riser на Английски и техните преводи на Български
{-}
-
Colloquial
-
Official
-
Medicine
-
Ecclesiastic
-
Ecclesiastic
-
Computer
Pipe diameter of 110 mm for the riser.
Using a flat screwdriver,release all visible staples in the riser.
The riser has mounting holes with a spacing of 3.6 cm width x 9.6 cm length.
The riser wire ultimately becomes the anode connection to the capacitor.
Because of this, problems can arise not only in you, but also throughout the riser.
Check valve can be installed in the riser pipe of a liquid it[Jun 30, 2015].
The Riser is an all-new instrument for designing musical transitions of epic proportions.
But in the case of multi-storey cottages without installing the riser is not enough.
If the riser is blocked only at the entrance, do not forget to warn the neighbors.
It calculates base of the riser demand with the Grid Calculator, Tree Calculator or Head by Head….
They called the plumber to replace the gasket, because The riser is switched off in the basement.
Recommended height of the riser in the range of 14-17 cm, width 25-32 cm tread for a full foot support.
Avoid sharp corners in the direction of movement of the riser, and on elevation, avoid contra-slopes.
A powerful, synth-based instrument, The Riser features all of the tools you need to compose heart-stopping transitions in one intuitive user-interface.
To do this,fold the width of the tread and the height of the riser(according to the drawing).
Most often there is a problem with the riser and it is this part of the sewer system that requires cleaning or replacement if it is old and cast iron.
In practice, the toilet away from the riser for 2-3 meters will have to be lifted on the podium to ensure a normal water discharge.
Lay the next track over this area andsecure its lower edge at the bottom edge of the riser, and then continue working as before.
If the riser is planned to be sewn, when installing the audit should take care of the inspection covers, intended for the maintenance of the pipeline.
If you have several tracks and one of them is over, cut off the excess ofthe used track so that the rest of it is securely attached to the riser.
Measure the necessary distance from the wall to the top of the riser and spout in the far upper corner of the wedge-shaped step.
Violation of the rules and requirements for the installation of plumbing:incorrectly chosen angle of the pipe leading to the riser(2 cm per 1 meter long);
Connect the discharge device to the riser using two elbows of 45 degrees, and on the riser above the floor level of the basement, establish a revision.
In suburban homes,where the bathroom is located on thetangible distance from the riser assembly inside of sewer gravity type is not always possible.