Примери за използване на Two screws на Английски и техните преводи на Български
{-}
-
Colloquial
-
Official
-
Medicine
-
Ecclesiastic
-
Ecclesiastic
-
Computer
For mounting it is only two screws.
Two screws for mounting the handle.
Basically take the two screws from each side.
The kit is easily installed by two screws.
Leave the two screws fastened in the slots for last.
Do not forget to use glue, butthen fasten two screws section.
Then remove the two screws that hold it in place.
Then, using a screwdriver,you will need to unscrew the two screws on the sequence.
Remove two screws from, the door pull handle.
The BC-FMT positioned in the mastoid is attached through two screws to the bone.
Then tighten the two screws that hold it in position.
Two screws, made of high-quality metal, rotate under the influence of electricity.
Mounting of the grip- two screws M4 mm for the cross screwdriver;
To increase the cutting accuracy and increase the safety of work,it is recommended to use two screws.
Remove the two screws holding the spring and check valves.
X15 cm boards along the perimeter of the square,screwing two screws into each end of the board.
The two screws are usually removed with a large Phillips screwdriver.
To do this, loosen the lid on the two screws on the back of the washing machine.
To do this,place the level on a horizontal circle approximately midway between any two screws for lifting.
Simple installation by means of two screws on the bottom, no external part to connect.
Then repeat the rotation of the telescope, setting it parallel to the line,which refers to the other two screws.
They are removed and two screws are screwed in their place, preferably grade M 6.
For this purpose, the handle is initially placed horizontally so thatthe aperture can be rotated in front of the two screws.
Immediately, the sheet is attached only by two screws that are diagonally spaced from each other.
Having established andhaving clamped a processed round timber combs, fix the movable part with two screws and immobilize.
Included: two upper parts, two screws 16 mm and two felt rings, and a small tool.
Before you start, you must first remove the rear wing liners on both sides,then unscrew the two screws that secure the bumper to the wheel arches.
Unscrew two screws(indicated by the arrows below) on the bottom of the computer and remove the memory module compartment cover.
Thus, such a movement is often associated with the action of two screws, fastening the part in question with alidade.
The first two screws, more precisely, the high and low rpm regulators, are used to control the flow of the combustible mixture and air.