Примери за използване на Waterproofing film на Английски и техните преводи на Български
{-}
-
Colloquial
-
Official
-
Medicine
-
Ecclesiastic
-
Ecclesiastic
-
Computer
Then the waterproofing film is lined.
Building a stapler we mount a waterproofing film.
Waterproofing film, waterproofing film for roofing.
Now a hydro-barrier or waterproofing film with perforation is used.
Waterproofing film for the roof. Roof waterproofing. .
Over lag and heat insulation is applied waterproofing film, and then- the boards of the floor.
Waterproofing film for the roof, the choice of material, advice| Do it yourself.
All these measures will save the waterproofing film from damage and extend its service life.
On the walls andthe floor grid is laid layervapor barrier on top- a layer of insulation and waterproofing film.
How to choose a waterproofing film for the roof and roof-.
For a mansard roof should choose higher-quality materials,such as waterproofing film based on polyethylene.
We plan on the waterproofing film the location of the window.
The tree burns very well, most types of insulation, too,as far as polymer vapor barrier and waterproofing films and say nothing.
You can use waterproofing films- polyethylene and polypropylene.
For this purpose, mineral wool is suitable,it is laid in the spaces between the lags and covered with a waterproofing film.
It is allowed to use waterproofing films- two ventilation gaps are necessary.
Again, when solving the problem of leakage from the side of the roof covering,it is necessary to install a waterproofing film under the crate.
When storing a waterproofing film, do not expose the material to direct sunlight.
A unique combination of steam and waterproofing properties does not allow using additional expensive materials(superdiffuse and waterproofing films).
It is acceptable to use waterproofing films with the device of two ventilation gaps.
If you lay a membrane on a non-insulated roof, some of its properties will not be used,so a perforated waterproofing film is the best option for"cold" roofs.
The waterproofing film is laid perpendicular to the slope, the laying allowance should be at least 150 mm.
On the bars of the first frame,on top of the waterproofing film, laths 2-3 cm thick and 0.5 mm wide are nailed.
One of the best options is to create a"pie", which consists of a thermal insulation material,a layer of vapor barrier and waterproofing film.
The heat insulating layer is covered with waterproofing film, which should be free flowing steam and retain water well.
Important: if as insulation mineral wool ceiling is chosen,then the long-term preservation of its properties it is necessary to arrange a waterproofing film gap for air.
It is also undesirable to use a waterproofing film on the roofs of a complex shape, where there are, say, several valleys, dormers, several levels, etc.
If the structure is provided with a lower groove, waterproofing film should reach to the edge of it, but if it does not exist- it is desirable to perform the bottom edge of the film, combining a roof gutter.
Waterproof film that captures the structural part and the part of the foundation.
Breathable waterproof film;