Примери коришћења Drill will на Енглеском и њихови преводи на Српски
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
-
Latin
-
Cyrillic
After that such drill will be unsuitable for further use.
First you must decide for what purpose the drill will be used.
An 8mm drill will drill two holes on each of the four boards.
It is also important to know that during operation the drill will heat up quite strongly.
The drill will rotate around its axis, as well as move back and forth.
Not everyone has a big puncher, and a battery-powered drill will be much more expensive.
The drill will be very easy to move and will serve you for years.
Iron holes are also suitable for small holes, butusually the iron drill will only make one or two holes.
The drill will be held in September in Banja Luka, the capital of BiH entity Republika Srpska(RS).
As with any machine, your drill will last longer if you maintain it well.
If mainly large drills are used, then it is better to install a key chuck,in which case the drill will last much longer.
Therefore, when working, such a drill will rub more against the metal and, accordingly, heat up more.
With this method of sharpening from both sides on the back of the pen you will get a cone, but the drill will remain without a cleaned back corner.
This type of drill will be reinforced, which will allow to drill wells, the depth of which is more than 2 m.
But when you need to drill foam concrete walls, the drill will be the best, since the drill will simply crush the surface.
This drill will help you to achieve and accomplish your tasks rather quickly by its powerful motor that was built with performance in mind.
The installation of the flexible shaft of the drill will replace the tachometer, which can simply be removed from the installation.
In this case, a complete disassembly of the punch will be required, after which the stuck drill will be knocked out with a punch.
When working in the drilling mode, the drill will rotate with a small axial runout, which must be taken into account.
If such a technique is exactly a perforator, and not a combined apparatus with a drill, then the drill will be a more fortified configuration.
An unaccented traditional drill will be completely useless for drilling in concrete, as this may cause a failure of the tool.
In this case, the balls, which are intended for fixing, are located inside the cartridge,fall into the closed grooves, and the drill will hold securely and firmly.
The service life of such a drill will be longer, because its speed is regulated by the system controller located on the power button.
Installing such a table after the purchase on its own does not pose any difficulty andany person who knows how to hold a screwdriver and use a drill will cope with it.
From what the purchased drill will be intended for, the difference in the function that may be built in or not needed at all may depend.
Even if the sharpening itself is bad, then it can still be straightened,whereas in the case of a curvature, the drill will burst with 1 approach with a high probability.
The drill will include simulated anti-air and anti-submarine warfare exercises, simulated small boat attacks and basic ship handling maneuvers.
The drill will involve experience sharing and will aim to develop coordination in carrying out practice combat tasks in a mountainous environment, including operations against illegal armed groups.
This year's drills will also include joint maneuvers with Belarus, Mongolia and other countries.
And the drills will continue per my orders.