Примери коришћења Output signal на Енглеском и њихови преводи на Српски
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
-
Latin
-
Cyrillic
The output signal from Block 2 is labelled ABS.
Real-time monitoring of input and output signal.
The output signal is the utterance produced by the child.
They differ, however, in what exactly serves as the output signal.
In addition, the output signal swings the full voltage between the low and high rails.
Allows the input signal to be added to the output signal.
However, the required output signal is often another real-world analog signal. .
Output capacitance(COSS) is the capacitance seen by an output signal;
Do not connect products that create an output signal, as this may damage the device.
All that needs to be added is another stage of transistors to invert the output signal.
The traffic flow and the output signal control the rubber conveyor to meet the measurement requirement.
Each base is connected to an input signal, andthe common collector point presents the output signal.
Do not connect products that create an output signal as this may cause damage to the.
The quality of the transistor on the control panel is checked visually(by color change) orby measuring the magnitude of the input and output signals.
Major properties(selectivity, range,the nature of the output signal, repeatability and reproducibility, response time, storage time) Enzymes in biosensors.
This is done by modulating the supply rails so thatthe rails are only a few volts larger than the output signal"tracking" it at any given time.
The output signal is used as the input to a counter module that counts the number of rising or falling edges that occur within a certain measurement period.
Please someone if I can lamurii Movistar about a device that has the phone jack input and output signal type for normal jack. computer.
For low distortion, the transistor must be biased so the output signal swing does not drive the transistor into a region of extremely nonlinear operation.
With this form of amplitude control, the oscillator operates as a near ideal linear system andprovides a very low distortion output signal.
The output signal is connected to an amplifier, headphones, or external device using standard interconnects, such as a TRS connector or an RCA connector.
If You Choose to increase the output, then nevertheless,Then depart the vents unbunged while the port increases the output signal, so you can find bass.
Nonlinear elements enrich the spectrum of the output signal with new components of the spectrum, and filters are used to isolate low-frequency components.
When an approaching finger causes an increase in the capacitance of the sensor,the frequency of the oscillator's output signal decreases, and thus the edge count also decreases.
Despite the fact that the input signal is analog and the output signal is analog, the amplification is achieved using transistors that are switched from fully on to fully off.
The integrity of the transistor located on the control panel is checked by inspection(by color change) or by measuring the voltage andcurrent of the input and output signals.
After establishing the operating point,when input signal is applied, the output signal should not move the transistor either to saturation or to cut-off.
This makes it unnecessary to use a power transformer during work, which helps to significantly reduce the weight of the welding machine andimproves the ability to control the output signal.
In a radio frequency(RF) transmitter,VFOs are often used to tune the frequency of the output signal, often indirectly through a heterodyning process similar to that described above.
Non-linear PCM encodings(A-law/ μ-law, ADPCM, NICAM)attempt to improve their effective dynamic ranges by using logarithmic step sizes between the output signal strengths represented by each data bit.