英語 での Broadcast address の使用例とその 日本語 への翻訳
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
-
Programming
Broadcast Address.
There are two broadcast addresses.
IP broadcast address for Network B.
A custom list of broadcast addresses.
Thus, the all-hosts address may not be used as an internet-wide broadcast address.
The last address is the broadcast address for the network.
All 1's in the networkID are reserved for use as an IP broadcast address.
For further discussion of broadcast addresses, see Section 3.3.6.
Hosts address may not be used as an internet-wide broadcast address.
This option specifies the broadcast address in use on the client's subnet.
This message MUST be broadcast to the 0xffffffff IP broadcast address.
This is for the network and broadcast addresses, which are not useable on hosts.
The broadcast address can be obtained by bitwise ORing the network address with the 1's complement of the net mask.
Both Ethernet and IPv4 use an all-ones broadcast address to indicate a broadcast packet.
The client then unicasts the DHCPINFORM to the DHCP server if it knows the server's address, otherwise it broadcasts the message to the limited(all 1s) broadcast address.
This address(the broadcast address) is the only duplicate peeraddress that ppp allows.
Determine valid host addresses as well as the subnet address and,for IPv4, the broadcast address of a given network.
Packets destined for this broadcast address are duplicated and transmitted from all ports when received by the switch.
In principle, the Destination Address may be a unicast address, an IP broadcast address, or a multicast group address. .
Like the Network address, this broadcast address can not be set as an IPaddress on the terminal or NW devices.
Implementers should beaware that applications depending upon the all-subnets directed broadcast address(f) may be unusable on some networks.
Client testing uses a broadcast address, so the-server IP address command line argument cannot be specified.
It was explained that the first IP address of the Network Part is called a Network address, but on the contrary,the last IP address of the Network Part is called a Broadcast address.
The peer_address parameter can be the broadcast address of the local network or a multicast group address assigned to NTP.
DISCUSSION Although the IP layer does not generally know link layer addresses(since every different network mediumtypically has a different address format), the broadcast address on a broadcast-capable medium is an important special case.
It gets the host information(IP address, netmask, broadcast address, etc.) from a DHCP server and configures the network interface of the machine on which it is running.
For IPv4, if the configured interface is found to be unplumbed, marked down, or to have a different IP address, subnet mask, or broadcast address from those obtained from DHCP, the interface is abandoned by DHCP control.
Aside from the IP address, and for IPv4 alone, the netmask, broadcast address, and the default router, the agent does not directly configure the workstation, but instead acts as a database which may be interrogated by other programs, and in particular by dhcpinfo(1).
Browse addresses(BrowseAddress) Specifies a broadcast address to be used. By default browsing information is broadcast to all active interfaces. Note: HP-UX 10.20 and earlier do not properly handle broadcast unless you have a Class A, B, C, or D netmask(i. e. no CIDR support). ex: x. y. z.255, x.