英語 での Driving current の使用例とその 日本語 への翻訳
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
-
Programming
Function Driving Current: 500mA.
Driving current. more than 10ms.
Pulse signal, driving current> 10mA.
However, the actual limitation is normally due to the finite driving current capability.
If more than 50 mA driving current is necessary, please use the AU-3500 Isolated summing amplifier together with it.
人々も翻訳します
Dry contact signal or +12V level signal orDC12V pulse signal with width of more than 100ms, driving current> 10mA.
Dry contact or 12V electrical level signal or>100ms 12V impulse signal, driving current> 10mA.
The brightness may vary depending on the driving current, inversely affecting the device's lifespan.
The driving current of stepping motors can be easily measured by using the DC current measurement function of the 7351 series.
LED lamps:High brightness LED lamps with wide viewing range and low driving current, consuming less power.
After unexplained drops in the mass flow rate and motor driving current in number 3 and 5 gas circulators, the hot run tests were stopped and the gas circuit opened up.
Access device input voltage dry contact or12V electrical level signal or>100ms 12V impulse signal or driving current>10mA.
Magnesium is higher on the galvanic scale, producing more driving current between the anode and the tank to better protect your tank over time.
Input interface: the relay switch signal or 12V level signal or 12V pulse width>100ms 12V pulse signal, driving current> 10mA.
Switching losses andself-consumption current losses affect the current required for the gate driving current of the power transistors within the IC and the control circuit.
With interface of relay switch(the dry contact signal or +12V electrical level signal orDC12V pulse signal of pulse width≥ 100ms, driving current≥ 10mA), compatible with all kinds of access controllers.
The overall light intensity emitted by the individual light-generating devices(both, buying light-generating devices that producedifferent amounts of light for a given amount of driving current, and driving the light-generating devices with different amounts of driving current); .
Drive Current(ID, SAT).
Standard drive current≤200mA, suitable for small control system.
Drive current:>200mA;
Standard drive current≤600mA, Max. current≤ 1.8A.
Drive current 2A(MAX single bridge).
Reliable operation at up to 1.5X nominal drive current.
Drive current Little-- 0.2 A.
LED Drive Current: 700MA.
Input interface:+12V level signal or pulse width>100ms 12V pulse, drive current>10mA.
Transistor output drive voltage=power supply voltage, Drive current≤500mA.
Input interface:+12V level signal or pulse width>100ms 12V pulse, drive current>10mA.