英語 での Linear amplifier の使用例とその 日本語 への翻訳
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
-
Programming
W Linear Amplifier.
I concluded the solid-state linear amplifier is the best.
My Linear Amplifier.
For low levels of volume, the amplifier operates as a normal linear amplifier.
Rig Linear Amplifier.
Designed specifically for amateur radio use adjacent to transmitters and linear amplifiers.
This Linear Amplifier.
The power-efficiency advantage of classical PWM-based Class D amplifiers has been overshadowed by external filter component cost, EMI/EMC compliance,and poor THD+N performance when compared to linear amplifiers.
M Band Linear Amplifier.
Linear amplifiers are ideal for applications requiring high bandwidth, high precision, and low electrical noise.
No interference to BTS by adopting linear amplifier with high gain and low noise;
Class AB linear amplifier applications in industrial and commercial FM/AM.
This photograph is an example of remodeling 144MHz50W linear amplifier HL-62V of the Tokyo high-power.
Integrated a linear amplifier circuit and photodiode on a single chip.
And the relay of the linear amplifier side must be anxious and be no use.
In linear amplifiers such as Class AB, significant amounts of power are lost due to biasing elements and the linear operation of the output transistors.
It is an example of remodeling 50MHz50W linear amplifier HL-66V of the Tokyo high-power. Remodeling is easy.
High power linear amplifier, depth coverage for outdoor and in-building;
Even if the mode switch of a linear amplifier is SSB, it uses it in the place of FM when remodeling it.
However, newer linear amplifiers with digital control, often referred to as buffer amplifiers, can help to improve overall receiver performance as well as expand dynamic range.
The ACOM 1000 HF Linear Amplifier is one of the world's best value in an amateur HF amplifier. .
Please use the linear amplifier described here without doing this remodeling with SSB. It is… butter….
Because I had had a lot of rigs and linear amplifiers of V/UHF, the switch circuits of the sending and receiving were united by the simple expedient.
Direct current is sent to the linear amplifier side(booster side) when transmitting from the main phone side(transceiver side), the direct current is detected on the linear amplifier side, and it adds to the RF detector circuit on the linear amplifier side.
Linear power amplifier and highly integrated modules to ensure the stability of the inter-modulation(IMD3).
Digital-to-analog converters(DACs) are used to translate the digital waveform to an analog signal,which is then amplified by a linear high-voltage amplifier to drive the transducer elements.