英語 での Maximum operating pressure の使用例とその 日本語 への翻訳
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
-
Programming
Maximum operating pressure.
(6) Hydraulic mast Diameter of cylinder: 80mm Maximum operating pressure: 8Mpa.
Maximum operating pressure.
Inlet thread type T is TAPER(R screw) and maximum operating pressure is 30 MPa.
Maximum operating pressure(MPa).
Please use each element within 40MPa accroding to maximum operating pressure.
Maximum Operating Pressure… 8 BAR.
Inlet thread type N shows TAPER(NPT screw) and maximum operating pressure is 30 MPa.
Maximum operating pressure: 8Mpa.
The maximum spread force is up to 8-14ton, maximum operating pressure is 700bar(HFSH-14).
Maximum operating pressure 210 bar.
The criteria used in determining the hazard potential are maximum operating pressure, volume or fluid group.
Maximum Operating Pressure 6.2bar.
The hose andhose end should not be rated to a pressure less than the maximum operating pressure system.
Maximum operating pressure of 3 bars.
Rotork: FAQ-Operating and design pressure differences What is the difference between maximum operating pressure and design pressure? .
Maximum operating pressure: 8bar.
Rexroth 4WREE Series Proportional Directional Valves Size 6,10 Component series 2X Maximum operating pressure 315 bar Maximum flow 180 l/min Features- Actuation is by proportional solenoids with central….
The maximum operating pressure is 15 bars.
The maximum operating pressure is 350 bar.
The maximum operating pressure in bar;
Maximum operating pressure Port P bar 315.
Maximum operating pressure: 40 kgf/cm2.
The maximum operating pressure drops 10%.
Maximum operating pressure difference 0.42MPa/25℃.
Maximum Operating Pressure 150 psi(10.5 kgf/ cm2).
The maximum operating pressure is 1000 psi(69 bars).
Maximum operating pressure Pilot control valve Pilot oil supply 1 bar 25… 315.
Maximum operating pressure rating of 250 psi at 70 degrees F ambient temperature.
The maximum operating pressure of the pump is 40MPa, over voltage and power off, shutdown, troubleshooting should be done before work.