英語 での Signal levels の使用例とその 日本語 への翻訳
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
-
Programming
Small signal levels.
They are compatible with 5 V and 3.3 V signal levels.
Indicate signal levels for each channel.
Visual indication of target and current signal levels.
Only signal levels above the threshold are processed.
DMI Converter can also be used for converting signal levels.
Only signal levels above the set threshold are processed.
Digital Outputs Up to 16 x, max. 30 mA,5 V CMOS signal levels.
Only signal levels below the set threshold are processed.
Note that there are some COM ports that use signal levels of less than(±) 5V.
Signal levels in wired communications applications are usually specified in dBm.
Find out more about handling digital and analog signal levels in this article.
Figure 2 shows the signal levels for both common and differential modes on the media.
The other case iswhen the TGCs are at maximum gain and the signal levels are small.
THRESH(-60 to 0 dB) Signal levels above the set threshold trigger the compressor.
The radio station alsohas a graphical spectrum analyzer with indication of signal levels.
Since the gap between signal levels is now much smaller, PAM-4 is more susceptible to noise.
The MAX1359B has dual 10:1 differential input multiplexers(muxes)that accept signal levels from 0 to AVDD.
At large input signal levels, the output amplifiers will limit C/N. One of the limiting factors is P1db.
Therefore, the MAX9933 allows the ASK receiver toeasily discriminate between small input'1' and'0' signal levels.
These blocks represent the signal levels under the Below and over the Above thresholds, respectively.
PON Signals Validation During service action,check for power level assessment of active components to validate signal levels for all services.
The signal levels of the individual mixer channels are indicated by the blue level meter on their volume faders.
Figure 1 depicts anegative ECL logic source that converts the signal levels to LVDS logic through such an AC-coupled link.
The signal levels, noise levels, and ACLR are indicted for the cascaded lineup at each stage's output. Figure 9.
Repeaters then determine the original sequence of the signal levels and send the clean signal to the next network destination.
Even better, signal levels can be below the noise floor, because the spreading operation reduces the spectral density.
If your WLAN troubleshooting scan shows areas of yellow andred signal levels, you may need to explore ways to boost your signal level. .
Digital isolators can deliver higher signal levels to their receivers and withstand very high levels of common-mode transients without data errors.
The histogram equalization ensures that the signal levels are only spent on the background and the objects(and not on levels in between).