英語 での To the actuator の使用例とその 日本語 への翻訳
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
-
Programming
Control unit will turn off all current to the actuator.
Rotork: New Valve Automation The careful assembly of the valve to the actuator is critical to ensure that an automated valve performs correctly and reliably.
After analysis,any required configuration changes can be uploaded into to the actuator.
Please contact us for due to the actuator etc being used.
Check the operation of ESD panel supplying the hydraulic fluid to the actuator.
Contact with the engine valveis typically through a"finger" type attachment to the actuator bearing directly on the valve stem or valve follower as most convenient.
This means from the sensor to the actuator.
In addition to the actuators installed when the sites were first built, new actuators have subsequently been retrofitted to manually operated valves to increase the scope of automation across the sites.
IQ-Insight software also enables the operator to pre-configure or update actuator settings on a PC,transfer them to the setting tool and transmit them out in the field to the actuator.
A suitable converter will be required between the PC's RS232 output port andthe RS485 data highway to the actuator.
Rotork: FAQ- Broken filter regulator What happens to the actuator if the filter regulator gets broken during the actuator stroke? In case of filter regulator loss and output pressure from the compressor above the minimum one during the air stroke, the actuator will continue the travel with no excess of torque produced.
No exposed piston rod to draw fly ash into the cylinder Compact/ high torque output Dual-opposed lip seals forlong life No'pinch points' integral to the actuator'No Play' coupling to eliminate hysteresis and wear 2-million stroke/ 3 year performance warranty Options: Direct mount or remote mount solenoid valve Discrete feedback limit switches Manual override See Main Type K Catalogue for further details.
This allows MTS TestSuite Multipurpose software to automatically compensate for error due to acceleration when the load cell is mounted directly to the actuator.
Duplicating the full functionality of the SI, data logs can be viewed anddownloaded locally at the RHS instead of gaining access to the actuator.
Immersion's Active Sensing technology makes up for the difference of haptichardware by re-calibrating the amount of power to send to the actuator based on its performance capability.
After the ball valve with actuator is assembled(with either the pneumatic or electric actuator), air or electricity is supplied to the actuator.
A solution called RPC(Reduce Pressure Consumption) has been developed to further reduce leakage on the solenoid valves when there are no commands to the actuators.