英語 での Voltage change の使用例とその 日本語 への翻訳
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
-
Programming
Voltage change rate:±1%.
Static electricity voltage change.
Only the voltage change will be notified.
The change in the magnetic flux density is taken out as a voltage change.
Voltage change/time is settable with front VR.
The point pressed by a finger ora pen is detected by measuring voltage changes.
What if the supply power voltage changes while the Uras Vibrator is in operation?
By combining multiple elements,the resistance change can be taken out as a voltage change.
When the power system voltage changes, maintain the constant of output voltage. .
It is a function of the gain-bandwidth of the LDO's control loop,and the size and slew rate of the input voltage change.
Torch riding plate, torch crash, voltage change, cut quality change etc.
By using a specific readout circuit(ROC or ROIC)that includes a current-to-voltage converter, a voltage change can be measured.
For DC, available voltage changes according to the time constant(L/R) on the short circuit.
This shows that tube current increases(produced by filament temperature increases)are much more important than tube voltage changes.
If this is the case, there is no voltage change at Port B, so the high isolation from the two ports is achieved.
A MR sensor detects a magnetic body like magnetic ink,and the structure which makes an output voltage change is explained easily here.
The virtually vertical voltage change part, indicated by the red arrow, represents the square wave component due to the ESR.
The hysteretic converter2 in Figure 3 turns the power FET on oroff based on the output voltage changes sensed by the converter.
If the excitation voltage changes, there will be a proportional change in both the offset voltage and the full-scale output.
By varying the control input voltage from 0 to 2.5V,the low-noise APD bias power supply produces an output voltage change from 71V to 24.7V.
The voltage change will also be monitored with a dielectric material, such as a plastic plate inserted into the space between the metal plates.
To accurately measure the electrical resistance change of the strain gage,form a bridge circuit to convert the resistance change to voltage change.
During start-up and voltage change, the device controls the output slew rate to minimize output-voltage overshoot and in-rush current.
When an electric current surge(caused by lightning, for example) is induced on the port, the piezo-resistor breaks down,and tiny voltage changes produce rapid current changes. .
As noted above, because in this example the principal driving forces for output voltage change are Vc and Vesr, irrespective of the type of capacitor involved, the capacitor with a large capacitance, that is, consequently a small ESR, is the key to reducing the output voltage fluctuations when the load declines suddenly in this manner.
When the strain-gauge load cells are deformed by the load acting on them, the load cell electrical resistances change, hence the load cell outputs a voltage change proportional to the load.
Static var compensator(SVC) A change in reactive power due to a change in load oran accident in the electric system induces voltage change at various locations throughout the system. Once a voltage change exceeding the allowable limit arises, adverse effects such as the interruption of the normal operation of the equipment and flicker illumination are induced. As a countermeasure, SVC is used.
How to ensure the normal operation of the vehicle-mounted DVR stable voltage and current is very important, but on the other hand, the input power of the device is fixed,byW U* IShows that the voltage change when the current is changing, with the current direction of the voltage change is always the opposite.
Ratiometric error is the relative deviation(%) from the proportional behaviour described above,i.e. if the output voltage changes 3% at a supply voltage change of 5% we have a 2% ratiometric error.
In this project, we will use Potentiometer to change input analog voltage of NodeMCU andsend the voltage changing data to remote MQTT client software.