LINE WIDTH 中文是什么意思 - 中文翻译

• 线宽
• 行宽

在 英语 中使用 Line width 的示例及其翻译为 中文

At this time, the visual line width is less than 5mm.
此时，视线的宽度小于5mm。

Of course, it is only the minimum limit of line width.
当然只是线宽线距的最低极限值。

Therefore, when the line width is very fine, a series of problems will arise.
因此当导线线宽十分精细时将会产生一系列的问题。

For example,'LineWidth', 2 specifies a line width of 2 points.
例如，'LineWidth',2指定2磅的线宽。

In actual work, the line width needs to be defined as different values according to design requirements.
在实际的工作中线宽需要按照设计需要定义为不同的值。

In general, the line spacing of serpentine traces isgt;= 2 times the line width.
一般来讲，蛇形走线的线距gt;=2倍的线宽。

As in the single layer PCB, ground and power line width should be at least 1.5 mm.
像在单层PCB中那样，地线和电源线的宽度最少应为1.5mm。

An opportunity to change graphical settings of technical indicators(color, line width);
一个改变技术指标（颜色，线宽）图形设置的机会;

In 2002, the line width of the P4 processor in ordinary microcomputers was reduced to 0.13mm.
年，普通微机中P4处理器的线宽缩小到了0.13μm，.

In general, the serpentine traces have a line spacinggt;= 2 times the line width.
一般来讲，蛇形走线的线距gt;=2倍的线宽。

As a result, you cannot change the line width, fill color, or other aspects of the shapes and text.
因此，不能更改线条宽度、填充颜色或形状和文本的其他方面。

Currently, only three companies in the world can achieve the line width of 10 microns.
目前在国际上只有三家公司可以做到10微米的线宽。

Line widths can be as small as 10um and depths up to 10um, marking the surface of parts of the"mm" size.
线宽可小到10um，深度可达10um以下，可对“毫米级”尺寸大小的零件表面进行标记。

Increasing the temperature or pressure of the absorbing material will also tend to increase the line width.
提高吸收材料的温度或压力，也会增加谱线的宽度。

One of the indicators for measuring chip integration is line width, which is the width of the wires on the circuit.
衡量芯片集成度的指标之一是“线宽”，即电路上导线的宽度。

Keep item descriptions or other blocks of text as short as possible, both in content and in line width.
保持项目描述或其他文本块尽可能简短，包括内容和行宽方面。

Each object has its individual settings- color, line width, additional levels- and will display on different timeframes.
每个对象都有其各自的设置-颜色、行宽、附加等级以及不同时间表上的显示。

However, the line width of the laser is limited by many factors and it is almost impossible to reach the theoretical value level.
但是，激光的线宽受到诸多因素的制约，几乎不可能达到理论值水平。

The available processes are HV-CMOS, BiCMOS, SiGE, CMOS, and the process line width is less than 0.35 micron.
可提供的工艺有HV-CMOS、BiCMOS、SiGE、CMOS，工艺线宽小于0.35微米。

The change in line width may not be avoided and the effective length of the intermediate inconsistency section should be minimized.
可能无法避免线宽的变化，应该尽量减少中间不一致部分的有效长度。

As a general standard, any change from straight line to image angle or different line width must be as smooth as possible.
作为一个通用标准，任何从直线到象角或不同线宽的变化，必须尽可能的平滑过渡。

For a general digital board, the power input line width can be 50 to 80 mils, and the signal line width can be 6 to 10 mils.
对一般数字板来说，电源输入线线宽可采用50～80mil，信号线线宽可采用6～10mil。

However, this must be compensated to reduce the impedance discontinuity caused by the local increase in effective line width going through the bend.
然而，必须对此进行补偿，以减小通过弯曲点时本地有效线宽增大引起的阻抗突变。

Radio-frequency line length should be as short as possible, line width is strictly in accordance with the calculated value to set.
如前所述，射频走线的长度要尽量短，线宽严格按照计算好的值去设定。

SHX, Xref and line width are adjustable, multi-sheet of DWF 6 is supported, which enables you to integrate all layouts in one DWF file.
SHX、XREF和线宽是可调整的，支持DWF6的多个片断，这使得您能够在一个DWF文件中集成所有布局。

The current printed board can be used for 4-5mil wiring, but usually 6mil line width, 8mil line spacing, 12/ 20mil pad.
目前印制板可作4-5mil的布线，但通常作6mil线宽，8mil线距，12/20mil焊盘。

With these parameters, you can calculate the line width, line spacing(3W), line length, then you can start drawing the board.
有了这些参数，就可以计算线宽、线间距(3W)、线长，这时就可以开始PCB设计了。

In order to meet various requirements, the FPC process must be upgraded, and the minimum aperture, minimum line width/line spacing must meet higher requirements.
为了满足多方面的要求，FPC的工艺必须进行升级，fpc多层板最小孔径、最小线宽/线距必须达到更高要求。

The 2S state in atomic hydrogen is long-lived, leading to a narrow natural line width, so it is particularly suitable for precision measurement.
氢原子的基态持续时间很长，这导致一个很狭窄的自然线宽，所以特别适合于精密测量。

The 2S state in atomic hydrogen is long-lived, resulting in a narrow all-natural line width, so it's particularly suited to precision measurement.
氢原子的基态持续时间很长，这导致一个很狭窄的自然线宽，所以特别适合于精密测量。