THE SYSTEM CLOCK 中文是什么意思 - 中文翻译

• 系统时钟

在 英语 中使用 The system clock 的示例及其翻译为 中文

On OS X, only admin users can change the system clock.
在OSX上，只有管理员用户才能更改系统时钟。

Switch the system clock to the external oscillator.
将系统时钟切换到外部振荡器。

Connectify is running in the Notification Tray next to the system clock.
Connectify的通知托盘中运行的系统时钟旁边。

Deep sleep mode stops the system clock and switches off the PLL and flash memory.
深度睡眠模式停止系统时钟并关闭PLL和Flash存储器。

Connectify is running in the Notification Tray next to the system clock.
Connectify在通知托盘中运行的系统时钟旁边。

Normally the system clock is 16MHz, but for the Arduino Pro 3.3V it is 8Mhz.
通常系统时钟为16MHz，但对于ArduinoPro3,3V则为8Mhz。

Three different clock sources can be used to drive the system clock(SYSCLK):.
可以使用三种不同的时钟源来驱动系统时钟(SYSCLK)：.

During In-System programming the system clock source of the target device can operate normally.
时，目标器件的系统时钟源可以正常工作。

Linux also provides the stime() system call for setting the system clock.
Linux提供stime（2）调用来设置系统时间。

The system clocks of all NTP-managed devices are synchronized to the millisecond precision.
由NTP管理的所有系统时钟都会同步精确到毫秒级。

The time or date stored in the system setup program does not match the system clock.
存储在系统设置程序中的时间或日期与系统时钟不符。

Chrony can synchronise the system clock faster with better time accuracy and it….
Chrony可以更快的同步系统时钟，具有更好的时钟准确度，并且它对于那些不是….

Active external 20 MHz crystal oscillator output frequency by the PLL circuit 15 to 300 MHz was used as the system clock.
外部20MHz有源晶振输出经PLL电路15倍频到300MHz后作为系统时钟。

The system clock can be any of the available clock sources including the PLL.
系统时钟可以是包括PLL在内的任何可用的时钟源。

Internal oscillator may still generate the system clock when the external oscillator is driving Timer 1.
内部振荡器仍可产生系统时钟时，外部振荡器驱动定时器1。

The system clock should use your time zone selection to display the correct date and time at the bottom of the screen.
系统时钟应该使用时区选择显示在屏幕的底部正确的日期和时间。

Using this parameter without enabling the PLL results in the system clock having the same frequency as the clock source.
所以不启用PLL而使用该参数的结果是系统时钟与时钟源频率相同。

Additionally, the system clock to the serial ports(except I2C) can be scaled relative to the CPU clock..
此外，到串行端口（除了I2C）的系统时钟可按照CPU时钟进行缩放。

During kernel startup, at the point when the RTC driver is loaded, the system clock may be set from the hardware clock..
系统启动装入rtc驱动时可能会根据系统时钟设置硬件时钟。

Microsoft has even improved the system clock in Windows by adding a calendar with a full list of your own events.
微软还改善了系统时钟，可以在日历中添加完整的事件列表。

The RF interface module of the card chip generates the power voltage, the reset signal and the system clock, The chip"activated";
卡中芯片的射频接口模块由此信号产生出电源电压、复位信号及系统时钟，使芯片“激活”；.

Timer 3 may be clocked by the system clock, the system clock divided by 12, or the external oscillator.
定时器3的时钟可以由系统时钟，系统时钟除以12，或外部振荡器.

In the long run, the frequency of execution will be exactly the reciprocal of the specified period(assuming the system clock underlying Object. wait(long) is accurate).
从长远来看，执行的频率将正好是指定周期的倒数（假定Object.wait(long)所依靠的系统时钟是准确的）。

Timer 3 may be clocked by the system clock, the system clock divided by 12, or the external oscillator.
定时器2的时钟源可以由系统时钟，系统时钟除以12，或外部振荡器.

The system clock on powerup is the internal clock(16 MHz) and after system initialization another external clock source can be selected in software.
启动时使用的系统时钟是内部时脉（16MHz），在系统起始化后可以透过软体选取外部时脉来源。

Internal oscillator drives the system clock while Timer 2(and/or the PCA) is clocked by an external precision oscillator.
内部振荡器驱动系统时钟，而定时器2（和/或PCA）的时钟由一个精确的外部.

And when the system clock reaches 120MHz, PCBs based on traditional methods will not work unless knowledge of high-speed circuit design is used.
而当系统时钟达到120MHz时，除非使用高速电路设计知识，否则基于传统方法设计的PCB将无法工作。

OpenNTPD gradually adjusts the system clock, as seen here in the output of OpenNTPD running on a Linux system:..
OpenNTPD逐步调整系统时钟，如在64位ArchLinux系统上运行OpenNTPD输出示例所示：.

And when the system clock reaches 120MHz, PCBs based on traditional methods will not work unless knowledge of high-speed circuit design is used.
而当系统时钟达到120MHz时，除非使用高速电路设计知识，否则基于传统艺术设计的PCB名将会成休克状态。