OUTLET PRESSURE Tiếng việt là gì - trong Tiếng việt Dịch

['aʊtlet 'preʃər]
['aʊtlet 'preʃər]

Ví dụ về việc sử dụng Outlet pressure trong Tiếng anh và bản dịch của chúng sang Tiếng việt

{-}
  • Colloquial category close
  • Ecclesiastic category close
  • Computer category close
Min outlet pressure, MPa 0.2.
Áp suất đầu ra tối thiểu, MPa.
Their performance- 600 l/ h, and the outlet pressure is 160 bar.
Hiệu suất của họ- 600 l/ h, và áp lực đầu ra là 160 bar.
Outlet pressure of clear liquid.
Áp suất đầu ra của chất lỏng trong.
The relief valve limits the outlet pressure of hydraulic pump.
Các van xả hạn chế áp lực đầu ra của bơm thủy lực..
Outlet pressure of clear liquid Mpa≤ 0.2.
Áp lực đầu ra của chất lỏng trong Mpa ≤ 0,2.
Compressor is acting continuously make the outlet pressure stable.
Máy nén đanghoạt động liên tục làm cho áp suất đầu ra ổn định.
Outlet pressure of clear liquid:≤0.2MPa.
Áp suất đầu ra của chất lỏng trong:. 20,2 MPa.
Electric proportional relief valve to control the outlet pressure of hydraulic pump.
Van xả tỷ lệ điện để kiểm soát áp lực đầu ra của bơm thủy lực..
Outlet pressure set range standard Wh: 15-70 mbar.
Thiết lập giới hạn áp Outlet Tiêu chuẩn Wh: 15- 70 mbar.
For example, a gas eliminator can beinstalled in front of the flow meter to increase the outlet pressure, etc.;
Ví dụ, một bộ khử khí có thể đượclắp đặt ở phía trước đồng hồ đo lưu lượng để tăng áp suất đầu ra, v. v.;
The outlet pressure does not vary along with the inlet.
Áp suất đầu ra không thay đổi cùng với đầu vào.
No need to irrigate water, the suction stroke is up to 2-7m,the lift is up to 50m, and the outlet pressure is≥6kgf/c m2.
Không cần tưới nước, đột quỵ hút lên đến 2- 7m, thang máylên đến 50m, và áp suất đầu ra là ≥ 6kgf/ c m2.
Outlet pressure set range Low pressure type 15-500mbar.
Thiết lập giới hạn áp Outlet loại áp suất thấp 15- 500mbar.
J-2 Rotors pump 3~5T/H SUS 304 material,mechanical seal, outlet pressure 0.6mpa, stepless speed regulating PCS 1.
J- 2 Bơm rotors 3~ 5T/ H SUS 304 vật liệu,con dấu cơ khí, áp lực đầu ra 0.6 mpa, điều chỉnh tốc độ không bậc PCS 1.
The outlet pressure fluctuation is very low and the waste water discharges very little when back-flushing.
Biến động áp suất đầu ra rất thấp và nước thải thải rất ít khi xả ngược.
If the valve is opened the pressurehas to decrease enormously before the valve closes and the outlet pressure of the valve can easily keep the valve open.
Nếu van mở ra, áp lực phảigiảm đáng kể trước khi van đóng và áp suất đầu ra của van có thể dễ dàng giữ van mở.
Accordingly, the outlet pressure can be safely and reliably maintained at a preset value and the preset.
Theo đó, áp suất đầu ra có thể được duy trì một cách an toàn và đáng tin cậy ở một giá trị đặt trước và cài sẵn.
To elect the higher pressures from multiple loads, pass it to a variable displacement pump control mechanism,as the basis for maintaining the pump outlet pressure.
Bầu áp suất cao hơn từ nhiều tải trọng, vượt qua nó để một cơ chế điều khiển bơm chuyển biến,làm cơ sở cho việc duy trì áp lực đầu ra của bơm.
High outlet pressure, able to meet the conveying requirements of high-rise buildings and long-distance construction.
Áp suất đầu ra cao, có thể đáp ứng yêu cầu vận chuyển của các tòa nhà cao tầng và xây dựng đường dài.
At this time, the adjustment of the valve is equivalent to increasing the pipe resistanceloss to achieve the effect of reducing the flow and the outlet pressure of the pipe end.
Tại thời điểm này, việc điều chỉnh van tương đương với việc tăng tổn thất điệntrở ống để đạt được hiệu quả giảm lưu lượng và áp suất đầu ra của đầu ống.
Change the outlet pressure, but for the life of water supply, fire protection system and industrial to the.
Thay đổi áp lực đầu ra, nhưng đối với cuộc sống cung cấp nước, hệ thống phòng cháy chữa cháy và công nghiệp đến.
Voltage regulation characteristics: the gas source pressure is in the range of 5-15 MPa,the inlet pressure changes by 1 MPa, and the outlet pressure changes by no more than 7X10-4 MPa.
Đặc điểm quy định về điện áp: áp suất nguồn khí nằm trong khoảng 5- 15 MPa,thay đổi áp suất đầu vào bằng 1 MPa, và các thay đổi áp suất ổ cắm không quá 7X10- 4 MPa.
Adjust and control the outlet pressure of the main valve, main valve outlet pressure is not due to the.
Một điều chỉnh và kiểm soát áp suất đầu ra của van chính,áp lực đầu ra van chính không phải do.
Due to the diversity of piping system layout and the special requirements of production process, there are often the following conditions or problems:(1)the pipeline outlet pressure changes with the process pressure difference;
Do sự đa dạng của bố trí hệ thống đường ống và các yêu cầu đặc biệt của quy trình sản xuất, thường có các điều kiện hoặc vấn đề sau:( 1)thay đổi áp suất đầu ra của đường ống với chênh lệch ápsuất quy trình;
The turbine outlet pressure of the boiler is not more than 9.2Mpa, and the minimum operating load of the boiler is 40% of the design.
Áp suất đầu ra của tuabin không quá 9,2 Mpa và tải trọng vận hành tối thiểu của lò hơi là 40% so với thiết kế.
The right side of the cavity pressure oil is sealed by the piston 2,when the left end of the piston 1(outlet pressure) to overcome the force of the spring on the piston, the piston 1 to the left side, while the piston 2 to the left as well.
Phía bên phải của dầu áp suất khoang được niêm phong bởi piston 2,khi đầu bên trái của piston 1( áp suất đầu ra) để vượt qua lực của lò xo trên piston, piston 1 sang bên trái, trong khi piston 2 bên trái là tốt.
The valves ensure outlet pressure stay in the setting valves stably on its own energy, namely the outlet pressure does not change owing to the inlet pressure's and flow's change.
Các van đảm bảo áp suất đầu ra ở trong các van thiết lập ổn định trên năng lượng riêng của nó, cụ thể là áp suất đầu ra không thay đổi do sự thay đổi của áp suất đầu vào và dòng chảy.
The right side of the cavity pressure oil is sealed by the piston 2,when the left end of the piston 1(outlet pressure) to overcome the force of the spring on the piston, the piston 1 to the left side, while the piston 2 to the left as well.
Phía bên phải của dầu áp lực khoang được đóng dấu của 2 piston,khi đầu bên trái của piston 1( áp lực đầu ra) để vượt qua lực lượng của mùa xuân trên piston, piston 1 về phía bên trái, trong khi 2 piston bên trái là tốt.
The system uses a directional valve outlet pressure as the control parameter, therefore, the hydraulic pressure presetting should refer to the numbers of lubrication points on-site.
Hệ thống sử dụng một áp lực đầu ra van hướng như thông số kiểm soát, do đó, presetting áp lực thủy lực nên tham khảo những con số của các điểm bôi trơn tại chỗ.
The valve is characterized by keeping the outlet pressure and temperature within a certain range in the case of constant changes in inlet pressure..
Van được đặc trưng bằng cách giữ áp suất đầu ra và nhiệt độ trong một phạm vi nhất định trong trường hợp thay đổi liên tục áp suất đầu vào.
Kết quả: 35, Thời gian: 1.2398

Từng chữ dịch

Truy vấn từ điển hàng đầu

Tiếng anh - Tiếng việt