Ví dụ về việc sử dụng This voltage trong Tiếng anh và bản dịch của chúng sang Tiếng việt
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
Usually this voltage is around 0.7V.
Following your tutorial I purchased this voltage stabilizer.
This voltage is referred to as Vpp in the UV-EPROM data sheet.
You will have to make sure yourcircuit will be able to handle this voltage.
This voltage ensures that the panels are capable of charging the battery fully.
The following Bus Terminals are also supplied with this voltage via the power contacts.
This voltage is applied to the base of the BC108B which will turn on slowly.
The generation of electricity in most modernpower stations is at 25 kV, and this voltage is then transformed to 400 kV for transmission.
This voltage can be used to power a mobile device or charge a battery.
A DC source willhave a nominal value voltage level and this voltage will fall as the source is loaded and outputs more current.
Typically, this voltage is 1-5 VDC because the resistor used is 250 ohms.
A diode or other type of suppression device must be connected across the coil of the solenoid to protect any other electroniccomponents in the circuit that may be damaged by this voltage.
Note that this voltage follows the voltage of the power supply.
This voltage transformer can only be used in 110 Volt and 220 volt countries.
A DC/DC converter steps this voltage down for components in the 12- volt electrical system.
This voltage is proportional to the average flow velocity and is picked up by two electrodes.
This voltage is proportional to the average flow velocity of the fluid and is measured by the two electrodes.
This voltage accumulates or depletes the electrons at the surface of these layers, writing bits of information into the memory.
This voltage is supplied through the microphone cable by a mixer equipped with phantom power or by some type of in-line external source.
When this voltage reaches 1/3 supply voltage, the flip flop is resetted to the initial condition and the cycle is repeated again.
If this voltage is significant it can be reduced(also reducing the inherent accuracy and precision of the measurement) by using a higher current range.
This voltage may be acceptable if the circuit has a low noise floor, but if a 2 Ω resistor could be included in the current path, the resulting 20 mV output voltage would be a major improvement.
The standard voltage ratings for this range of medium voltage cables is.
In this case Voltage.
This high voltage powers the magnetron to heat the food.
Considerable effort was made to convert this DC voltage into sound energy.
This low voltage inverter is one of the most popular general purpose drives among the automation industry.
But this low voltage level power can not be transmitted directly to the consumer end as because this low voltage power transmission is not at all economical.