Eksempler på brug af The cpu på Engelsk og deres oversættelser til Dansk
{-}
-
Colloquial
-
Official
-
Medicine
-
Financial
-
Ecclesiastic
-
Official/political
-
Computer
The CPU is still up.
Can you beat the CPU opponents?
The CPU could be shot.
This transmitter will override the cpu.
Yes. Pull the cpu by its base tap.
Folk også translate
I have to get this into the cpu interface.
The CPU time is used only for while when.
So, I tried a stress test of the cpu, cpuburn.
The CPU from the first terminator.
NoVBRMove/S must not be set and the cpu must be at least a 68010.
Monitor the CPU temperature and frequency real time.
Amazing 3d formula 1 style racing in flash,Race against the cpu in this fun racing game.
The CPU and Swap plug-ins have been ported to OpenBSD.
If you see svm or vmx in the cpu flags field, your system supports KVM.
This fan was placed to blow air out of the back of the case from just behind the cpu heat sink.
Fight the cpu or another player on the same keyboard.
For this to work, the VBR must be moved by WHDLoad(NoVBRMove/S must not be set and the cpu must be at least a 68010) and the freezer must be active.
Remove the CPU miner virus, using the fake service.
I finally came to the conclusion it was hardware and likely either cpu orsystem board my money was on the cpu, but I wasn't 100% certain.
Use the CPU tab to associate processes with Windows Services.
Race the cpu cars to get the fastest time possible in this great 3d flash racer.
If the access was an access to the instruction stream(i.e. the cpu attempts to load code) it will always be emulated, or with other words the resload_Protect?
Fight the cpu or another player on the same keyboard. watch out for those power moves!
Additional, if the VBR is moved by WHDLoad(NoVBRMove/S is not set and the cpu is at least a 68010) it will compare the FreezeKey with the actual keyboard value at each interrupt.
QuitKey/K/N Sets the rawkey code to quit the program,this works only if the VBR is moved by WHDLoad(NoVBRMove/S must not be set and the cpu must be at least a 68010) or the Slave itself supports it.
Hardware information, about the cpu, memory, network and battery us supported as well.
If you are using one of the supported software freezers(HRTmon or Thrillkill) you can use this option to setup a rawkey code on which pressed WHDLoad will enter the freezer. For this to work,the VBR must be moved by WHDLoad(NoVBRMove/S must not be set and the cpu must be at least a 68010) and the freezer must be active. Check also the chapter System Monitors/ Freezer for futher infos.
This transmitter will override the cpu and make the network think that you are the sys admin… uh, the system administrator.