Exemples d'utilisation de Coupling nut en Anglais et leurs traductions en Français
{-}
-
Colloquial
-
Official
Coupling nut and regulator not fully connected.
The rods are threaded into the coupling nut for a certain distance.
Coupling nut and regulator not fully connected.
Stainless steel nut is inclusive the hexagon coupling nut.
Turn the coupling nut clockwise and tighten to a full stop.
At the drain connection secure the coupling nut and seal cone seal.
Coupling nut and regulator not fully connected.
Used with threaded rod, the coupling nut joins two pieces of threaded rod.
Coupling nut and LP cylinder valve not fully connected.
Integrated hex wrench for loosening the coupling nut, 34 mm, pin pitch: 55 mm.
Turn the coupling nut clockwise and tighten to a full stop.
Use a marker orpen to mark a line on the coupling nut and unit panel.
Then tighten the coupling nut an additional one-quarter turn.
Remove the protective cap from the LP tank valve and coupling nut, if present.
Possible Cause 2: Coupling nut and regulator not fully connected.
The packaging density of QN increased compared to N thanks to the fact that no torque spanner is required to fasten the coupling nut.
Regulator tube coupling nut is not fully connected to Venturi.
Coupling nut and regulator not fully connected Turning the coupling nut about one-half to three quarters additional turn until solid stop.
This can be completed by fastening the coupling nut to the tank fitting, and the compression fitting to the shut-off valve.
The coupling nut connects to the large outside threads on the valve outlet.

