Exemples d'utilisation de Etching mask en Anglais et leurs traductions en Français
{-}
-
Colloquial
-
Official
And removing said etching mask.
The etching mask is then removed.
Eliminating the second etching mask.
The second etching mask is eliminated.
Removal of the second etching mask.
Etching mask 312 can also be eliminated.
Removing the second etching mask.
Etching mask 13 is then removed(FIG. 10.
Deposit of a secondary etching mask 5.
Forming an etching mask on the first conductive layer;
Only the geometry of the etching mask changes.
Etching mask 16 is produced by means of any suitable technique.
In FIG. 3 the etching mask 18 is removed.
This must be done for each side of the etching mask.
The constraints on the etching mask may thus be relaxed.
The blocks 120 a,120 b therefore act as etching mask.
Click the picture to see the etching mask to the exact scale PDF.
This layer 107 is intended to form an etching mask.
Second etching mask 6 is also called hard mask. .
There is even no need for an etching mask.
Then the etching mask 20 is eliminated, as described previously.
The voids are also present in etching mask 8.
An etching mask 112 is formed on insulating layer 108.
See this PDF for the diagram and etching mask of the PCB.
The etching mask is eliminated above the first active area.
This layer serves as an etching mask to delineate the layer 10.
For this, a tertiary etching mask 7 is deposited on the substrate 1.
First isolation material 14 is also deposited on etching mask 8.
Attention: the etching mask must be turned over for etching the tracks.