Exemples d'utilisation de This command should en Anglais et leurs traductions en Français
{-}
-
Colloquial
-
Official
This command should be used alone.
Copy Get-SPWOPIZone The WOPI zone displayed by this command should be internal-http.
This command should return the following.
D/dispatcher_in reload This command should be followed by an output shown below.
This command should produce something like.
Note: This command should be on one line.
This command should output this. .
Remarks This command should be used for all full backups.
This command should start the boot. md service.
However, this command should have the same effect on these machines as"TYPE I.
This command should return something like.
When powered down, this command should be accepted but will not do anything except return the power state.
This command should be used before TAKETHIS and.
This command should produce the following output.
This command should be executed from the Active WIC.
This command should be run as a root user.
This command should work in all circumstances.
This command should generate a 28 characher string.
This command should at least return SUSE_SLES-SP4-migration.
This command should produce output similar to the following.
This command should be run when the ATHENA ribbon is not displayed.
This command should be used to verify the multilink connection.
This command should only be used when the receiving server is being.
This command should display the IP address of your Internet connection.
This command should give you a list of Wi-Fi card information.
This command should return a list of AWS CodeCommit commands. .
This command should respond positively if your photobooth is properly connected to Wallee.
This command should produce output that begins with information that is similar to the following.
Note: This command should have created the gm0, device node under the/dev/mirror directory.
This command should return(along with a 200 status) a JSON-encoded content similar to this one.
