What is the translation of " 的抗压强度 " in English?

• compressive strength
• compression strength

Examples of using 的抗压强度 in Chinese and their translations into English

材料的抗压强度不同于它们的抗拉强度。
The compressive strength of the materials is different from their tensile strength..

A型瓦楞纸板具有最高的平面压力和较高的抗压强度，而b型瓦楞纸板具有相反的效果。
Type A corrugated board has the highest flat pressure and high compressive strength, while type B is the opposite.

不幸的是,他们只有有限的抗压强度，还没有被广泛接受。
Unfortunately, they had only limited compression strength and were not widely accepted.

为了进一步保持在水侵蚀下的抗压强度，研究小组添加了硅粉。
To further retain the compressive strength under water attack, the team added silica fume.

不幸的是,他们只有有限的抗压强度、没有被广泛接受。
Unfortunately, they had only limited compression strength and were not widely accepted.

当污泥含量大于30%时，污泥砖的抗压强度不能达到砖的性能标准。
When the sludge content is higher than 30%, the compressive strength of the sludge brick can not reach the performance standard of the brick.

MOC的抗压强度比常规水泥高得多，而且这种令人印象深刻的强度可以很快实现。
MOC has a much higher compressive strength than conventional cement and this impressive strength can be achieved very fast.

UPW级别的树脂具有很高的离子转换率(95%小)，卓越的电导率和TOC的清洗特性和强的抗压强度。
UPW grade resin has a very high ion conversion rate(95% minimum), excellent conductivity and TOC cleaning characteristics and superior compressive strength.

当粉煤灰和硅粉与MOC糊(每种添加剂的15%)混合时，在水中保持28天的完全抗压强度。
When fly ash and silica fume were combined with MOC paste(15% of each additive), full compressive strength was retained in water for 28 days.

依照标准实验方法测得的具有95%保证率的抗压强度作为混凝土强度等级。
The compressive strength with a 95% guaranteed rate measured according to the standard experimental method is taken as the concrete strength grade.

谈到金属时，重要的是要注意到金属的抗压强度。
While talking about metals it is important to note that the compressive strength of that metal is taken into consideration.

该材料提供高达29,000磅/平方英寸(psi)的抗压强度和高达7,000psi的弯曲强度。
The material provides compressive strengths up to 29,000 pounds per square inch(psi) and flexural strengths up to 7,000 psi.

该设计还可以包括能量吸收和力扩散区域，其可以用于减轻由事故引起的损坏，每个区域具有不同的抗压强度。
The design could also include energy-absorbing and force-spreading regions, which can be used to mitigate damage caused through accidents, with each having differing compressive strengths.

CBN的抗压强度（strength很高，这意味着在恶劣的条件下使用时它能保持颗粒完整而不易破碎;
CBN High compressive strength means that it maintains particle integrity and is not easily broken when used under harsh conditions;

最终产品是一种防潮，闭孔结构，由90％的空气组成，但可以承受高达276kPa（40psi）的抗压强度。
The final product is a moisture-resistant, closed-cell structure consisting of 90-percent air, yet can possess a compressive strength of up to 276 kPa(40 psi).

足够的抗压强度和疲劳强度；.
(1) sufficient strength and stiffness;

因为传感器安装在液压缸的压力范围内，所以它们必须具有与液压缸本身相同的抗压强度。
Because the sensors are installed in the pressure area of hydraulic cylinders, they have to have the same pressure resistance as the cylinder itself.

具有较好的抗拉、抗压强度：但其柔性不如其他塑料管件。
Has better tensile and compressive strength: but its flexibility is not as good as other plastic pipes.

所有的氧化铝都非常硬且耐磨的，具有很高的抗压强度，即使对极端温度和腐蚀性环境。
All aluminas are very hard and wear resistant, with high compressive strength even against extreme temperatures and corrosive environments.

铜套有一定的机械强度，能满足施工的要求，一般其抗压强度应≥0.3MPa。
Copper jacket has a certain mechanical strength, can meet the requirements of construction, generally its compressive strength should be≥ 0.3MPa.

奥斯陆的片麻岩，抗压强度高达300兆帕，是能够使用机械化隧道掘进技术成功开挖的最坚硬的岩石之一上。
With a compressive strength of up to 300 MPa, the gneiss in Oslo is one of the hardest rocks ever successfully excavated with mechanized tunnelling technology.

美国材料试验协会ASTMC39/C39M提供了圆柱形灌浆料试样抗压强度的标准试验方法。
American Society for Testing Materials ASTM C39/C39M provides Standard Test Method for Compressive Strength of Cylindrical Concrete Specimens.

抗压强度根据石材的种类和原产地而不同，约为1000-3000kg/cm。
The compressive strength varies from stone variety to origin and is about 1000-3000 kg/cm.

一般结构的灌浆料抗压强度在商业和工业结构中从15MPa（2200psi）到30MPa（4400psi）以及更高。
Concrete compressive strength for general construction varies from 15 MPa(2200 psi) to 30 MPa(4400 psi) and higher in commercial and industrial structures.

一般结构的灌浆料抗压强度在商业和工业结构中从15MPa（2200psi）到30MPa（4400psi）以及更高。
Concrete compressive strength for general construction fluctuates from 15 MPa(2200 psi) to 30 MPa(4400 psi) and elevated in commercial and industrial structures.

对于包装的抗压强度有较高要求的用户来说话，运用微瓦包装是一个比较理想的选择。
For users who have higher requirements on the compressive strength of packaging, using microwatt packaging is an ideal choice.

抗压强度：接受（常温）的最大压力能力。
Compressive strength: Ability of bearing the maximum pressure(normal temperature).

它通常用于不需要高拉伸强度或抗压强度的应用中。
It is typically used in applications that do not demand high tensile strength or compression resistance.

抗压强度根据石材的种类和原产地而不同，约为1000-3000kg/cm。
The compressive strength varies according to the variety and origin of the stone, about 1000-3000 kg/flat method cm.

由于其特殊的结构，它可以提高抗压强度，纸蜂窝板可以降低成本。
Because of its special structure, can improve compressive strength, paper honeycomb plate can reduce costs.