Wireless InSite offers three methods for bit error rate analysis:.
可以同时测量三个4PAM眼图的误码率。
The bit error rates of three PAM-4 eye patterns can be measured simultaneously.
数字1%误码率.
An error rate of 1%.
各支路的误码率为.
The error rate of each line is.
其特点是信息输入速度快,误码率低,但数据容量小,损坏后无法读取条形码。
It is characterized by fast information entry,low input error rate, but small data capacity, and the bar code cannot be read after being damaged.
设传输二进制数据总数为N位,其中出错的位数为Ne,则误码率表示为:.
Let the total number of transfer N-bit binary data,in which the median error Ne, the error rate is expressed as:.
在复活的信念是美丽旧上午表示,从误码率采取的祝福。
The belief in resurrection is beautifully expressed in the old Morning Benediction,taken from Ber.
最新的APxV4.1软件版本同时包括了数字误码率测试功能。
With AP's latest software release, v4.1, digital error rate test capability is also available.
吞吐量和误码率计算将应用于每个点对点链路的每个结果数据流,以确定结果。
Throughput and BER calculations will then be applied to each of the resultant data streams for each point-to-point link in order to determine the results.
新南威尔士大学工程师的试验效果表明,误码率低至0。
The experimental result by University ofNew South Wales engineers demonstrated error rates as low.
在这方面,误码率BER,也可以定义为错误概率(probabilityoferror)或POE。
In terms of this, the bit error rate, BER, can also be defined in terms of the probability of error or POE.
顾名思义,误码率被定义为传输系统中发生错误的比率。
As the name implies, a bit error rate is defined as the rate at which errors occur in a transmission system.
误码率是反映一个机器可识别标签系统错误识别情况的极其重要的测试指标。
The code error rate is an extremely important test indicator that reflects the misidentification of a machine-recognizable tag system.
高度的识别稳定性(误码率小于10万分之1);.
High degree of recognition stability(bit error rate of less than 1 per 100,000).
符号率和占用带宽与以前相同,误码率明显较低,“用户注意到。
Symbol rates and occupied bandwidths are the same as before, and false-decode rates are significantly lower," the user notes explain.
误码率(BER:biterror)是衡量数据在规定时间内数据传输精确性的指标。
Bit Error Rate(BER) is a measure of performance of a data transmission medium.
它是在实验室或要求苛刻的制造环境中进行误码率(BER)测试和系统验证的理想解决方案。
It is the ideal solution for bit error rate(BER) testing and system verification in labs or demanding manufacturing environments.
对于一个条形码系统来说,误码率是比一次识别率低更为严重的问题。
For a bar code system, the bit error rate is lower than the first recognition rate is more serious problem.
对于一个条形码系统来说,误码率是比一次识别率低更为严重的问题。
For a bar code system, the bit error rate is a more serious problem than the low recognition rate..
另外,aptXLive还具有在误码率(BER)过高的情况下稳定连接的技术。
In addition, aptX Live also featurestechniques that aid connection in situations where the bit error ratio(BER) is excessively high.
The ADF5610 is manufactured using Analog Devices' proprietary advanced silicon germanium(SiGe)BiCMOS process with low bit error rate.
接收器平面的这种传输波束振动减少了平均接收的信号,从而增加了误码率。
Vibration of the transmitted beam in the receiver plane decreased the average received signal,thus increasing the bit error rate.
同时,第一读取速率越高,误码率越高。
At the same time, the higher the first reading rate,the higher the bit error rate.
在8位编码被传送的同时,它们的反码也被传送,这样就大大减少了系统误码率。
After each 8-bit code is transmitted, their inverses are also transmitted,reducing the system's bit error rate.
此外,还必须进行网络端到端的鉴定,这时会执行所有相关的SONET/SDH测试,包括误码率等测试。
Furthermore, network end-to-end level qualification is required where all the relevant SONET/SDH tests are performed,including tests such as bit error rate.
如图1所示,这些高速I/O接口需要低抖动定时参考,以最大限度地降低误码率并提高整体系统性能。
As shown in Figure 1, these high-speed I/O interfacesrequire low-jitter timing references to minimize bit-error rate and improve overall system performance.
中文
Bahasa indonesia
日本語
عربى
Български
বাংলা
Český
Dansk
Deutsch
Ελληνικά
Español
Suomi
Français
עִברִית
हिंदी
Hrvatski
Magyar
Italiano
Қазақ
한국어
മലയാളം
मराठी
Bahasa malay
Nederlands
Norsk
Polski
Português
Română
Русский
Slovenský
Slovenski
Српски
Svenska
தமிழ்
తెలుగు
ไทย
Tagalog
Turkce
Українська
اردو
Tiếng việt