What is the translation of " DECOMPOSITION TEMPERATURE " in Chinese?

• 分解温度

Examples of using Decomposition temperature in English and their translations into Chinese

Its decomposition temperature(65~ 85° C) is suitable for most reactions;
它的分解温度（65～85°C）适用于大多数反应；.

This temperature is called the decomposition temperature.
这种温度称为DistributionTemperature。

The decomposition temperature was about 280° C, and no caramelization reaction occurred.
分解温度约280℃，不产生焦糖化反应。

The solubility in water is 0.0008% and the decomposition temperature is 200-220 °C. Low toxicity.
在水中的溶解度为0.0008%，其分解温度为200-2200C低毒。

The decomposition temperature was about 280° C, and no caramelization reaction occurred.
分解温度约280℃，不发生焦糖化反应。

The more peroxide content in organic peroxides, the lower the decomposition temperature, the greater the risk.
有机过氧化物中的过氧基含量越多，其分解温度越低，危险性就越大。

The decomposition temperature was about 280° C, and no caramelization reaction occurred.
分解温度约为280℃，不发生焦糖化反应。

Usually, it becomes soft when heated to 160℃ and starts to flow at around 180℃, while the decomposition temperature is 270℃.
通常，加热到160℃时变软，开始在180℃左右流动，分解温度为270℃。

The decomposition temperature was about 280° C, and no caramelization reaction occurred.
分解温度约280℃，不会发生焦糖化反应。

At the same time, the injection temperature is also limited by thermal degradation temperature and decomposition temperature.
同时，注射温度也受到热降解温度、分解温度的限制。

The decomposition temperature is high, and the oxidation is much lower than that of lithium cobaltate.
其分解温度高，氧化性能远低于钴酸锂。

Once the ammonium paratungstate is prepared, it is heated to its decomposition temperature, 600 °C. Left over is WO3, tungsten oxide.
仲钨酸铵一旦准备，它被加热到它的600℃分解温度，剩下的就是三氧化钨，氧化物。

Good thermal stability, decomposition temperature 350 C, especially suitable for glass fiber reinforced PA66 flame retardant….
热稳定性好,分解温度≥350℃,特别适用于玻纤增强PA66的阻燃。

The injection temperature range is wide, the melting temperature is 160 degrees, and the decomposition temperature reaches 270 degrees.
注射温度范围宽，熔化温度为160℃，分解温度为270℃。

And phosphoric acid lithium battery decomposition temperature at 800℃, more is not easy to catch fire, security is relatively high.
而磷酸锂电池的分解温度在800℃，更不容易着火，安全性相对较高.

Focusing on allowing materials and devices to withstand higher operating temperatures(high Thermal Decomposition Temperature) Strategy;
侧重于让材料和器件能够经受更高操作温度（高TD裂解温度）的耐热策略;

Decomposition temperature and time According to the nature of SiC, 1050e and 1100e were selected to decompose the sample, and the results were consistent.
分解温度及时间根据SiC的性质，选用1050e及1100e分解试样，测定结果一致。

The most representative of these rubbers is dimethyl silicone rubber, which has an oxygen index of about 25 and a thermal decomposition temperature of 400 to 6001:.
这类橡胶中最有代表性的是二甲基硅橡胶，其氧指数为25左右，热分解温度在400〜6001：。

Therefore, the decomposition temperature or boiling point of the selected surface modifier is preferably higher than the processing temperature at the time of application.
因此，所选择的表面改性剂的分解温度或沸点最好高于应用时的加工温度。

The following requirements apply to portable tanks intended for the transport of organic peroxides(Type F) with a Self-Accelerating Decomposition Temperature(SADT) of 55 oC or more.
下述要求适用于运输自加速分解温度为55℃或更高的(F型)有机过氧化物的便携式罐体。

RPVC, in particular, due to its processing temperature and decomposition temperature is very close, often due to improper temperature control caused decomposition phenomenon.
尤其是rpvc由于其加工温度与分解温度非常接近，常常因温度控制不当而分解。

For example, certain water-soluble polymeric materials can exhibit a relatively large temperature difference between the melting temperature and the decomposition temperature.
例如，某些水溶性聚合物材料可在熔融温度和分解温度之间表现出较大的温差。

Features: 1 glass transition temperature 105° C, melting temperature greater than 160° C, decomposition temperature 270° C, molding temperature range is very wide.
特点:①玻璃化温度105℃，熔融温度大于160℃，分解温度270℃，成型温度范围很宽。

Self-accelerating decomposition temperature(SADT) means the lowest temperature at which self-accelerating decomposition may occur for a substance in the packaging as used in transport.
自加速分解温度（SADT）是一种物质在其用于运输的包装中可能产生自加速分解的最低温度。

RPVC, in particular, due to its processing temperature and decomposition temperature is very close, often due to improper temperature control caused decomposition phenomenon.
特别是RPVC，因其加工温度与分解温度很接近，往往因为温度控制不当造成分解现象.

The onset temperature and decomposition energy may be estimated using a suitable calorimetric technique(see 20.3.3.3).
可以用适当的热测量方法来估计起始温度和分解热(见20.3.3.3)。

Readily capable of detonation or explosive decomposition or reaction at standard temperature and pressure;
易于在标准温度和标准压力发生起爆或爆炸分解或反应；.

The higher the temperature, the more dirt decomposition, but when the temperature reaches 70℃~ 80℃, then affect the ultrasonic function, reduce the cleaning effect.
温度越高，越有利于污物分解，但当温度达到70℃～80℃以后，便影响超声波发挥作用，降低清洗效果。