Examples of using Dynamic routing in English and their translations into Chinese
{-}
-
Political
-
Ecclesiastic
-
Programming
Dynamic Routing.
动态路.This algorithm is called“dynamic routing between capsules”.
这种算法被称为“dynamicroutingbetweencapsules”。(Dynamic routing protocols are WAY outside the scope of this answer, though.).
动态路由协议是办法但是，在这个答案的范围之外。He has recently published a paper on this topic, titled Dynamic Routing Between Capsules.
老爷子上周刚刚发表了一篇论文，题为DynamicRoutingBetweenCapsules。Dynamic routing allows the best path to be determined and adjusted based on responses to network change.
动态路由根据网络变化确定和调整最佳路径。RIP protocol is the most common is an internal agreement,commonly known as dynamic routing information protocol.
RIP协议是最为普遍的一种内部协议，一般称为动态路由信息协议。If you select dynamic routing, the IP prefix is advertised automatically to your VPC through BGP.
如果您选择动态路由，IP前缀会通过BGP自动传播到您的VPC。As an edge service application,Zuul is built to enable dynamic routing, monitoring, resiliency and security.
作为边界服务应用，Zuul是为了实现动态路由、监视、弹性和安全性而构建的。To support dynamic routing protocol, you also need to configure the tunnel interface with a network address.
为了支持动态路由协议，也需要配置Tunnel接口的网络地址。Version 2.0 of Hirschmann's Security OperatingSystem adds enhanced VPN connections and dynamic routing for industrial networks.
赫斯曼安全操作系统2.0版为工业网络带来增强型VPN连接和动态路由.They also need to know which dynamic routing protocol is most appropriate in a particular network environment.
他们还需要知道哪个动态路由协议最适合特定的网络环境。A directly connected network is always the preferred source,followed by static routes and then various dynamic routing protocols.
直连网络始终是优先选用的路由来源，其次是静态路由，然后是各种动态路由协议。Dynamic routing protocols automatically adjust to changes without intervention from the network administrator.
动态路由协议能够自动调整以适应网络变化，无需网络管理员干预。RIP（RoutingInformationProtocol）协议是一种距离矢量路由协议（distance-vectorroutingprotocol）。Unlike dynamic routing, static routes are fixed and do not change if the network is changed or reconfigured.
与动态路由不同，静态路由是固定的，不会改变，即使网络状况已经改变或是重新被组态。RIP protocol is the most common is an internal agreement,commonly known as dynamic routing information protocol.
RIP（routinginformationprotocol）协议是最为普遍的一种内部协议，一般称为动态路由信息协议。Unlike dynamic routing, static courses are settled and don't change if the system is changed or reconfigured.
与动态路由不同，静态路由是固定的，不会改变，即使网络状况已经改变或是重新被组态。The only intelligent routing capabilities were found in spanning tree, dynamic routing, and hardware/software failure recovery protocols.
生成树中发现了唯一的智能路由功能，动态路由,和硬件/软件故障恢复协议。In contrast with dynamic routing, static routing calls for routes to be established by the network administrator.
与动态路由相比，静态路由要求通过网络管理员建立路由。Molex scalable WSS modules and signal routing solutions simplify andautomate the dynamic routing of wavelengths in demanding networks.”.
Molex的WSS模块和信号路由解决方案可以良好扩展，在高要求的网络中可以简化波长的动态路由并为其实现自动化。When choosing between these two dynamic routing protocols, there is almost no difference in their implementation and outcome.
在选择这两种动态路由协议时，它们的实现和结果几乎没有差别。Easy IT integration of the seller's inventory into the DHL shipping process,end-to-end tracking, dynamic routing and distribution, returns management, etc.
便捷地将卖家的库存与DHL运输流程进行信息技术整合、进行端到端跟踪、动态路线规划和分发、退货管理等。The processing of dynamic routing protocol updates could have a significant impact on the ability of a router to forward data frames.
动态路由协议更新过程会对一个路由器转发数据帧的能力产生重大的影响。Network professionals must understand the different routing protocols available in order tomake informed decisions about when to use static or dynamic routing.
网络工程师必须了解不同的可用路由协议，这样才能在选择静态或动态路由时作出明智决策。Unlike dynamic routing, the static routes are considered to be fixed and don't change if the network occurs or are reconfigured.
与动态路由不同，静态路由是固定的，不会改变，即使网络状况已经改变或是重新被组态。In the 1980s,AT&T replaced the static hierarchical network scheme with a dynamic routing scheme called DNHR(Dynamic Non-Hierarchical Routing). .
Z-Wave uses a dynamic routing technique where each Slave has a routing table that is written by Controller.
Z-Wave采用了动态路由技术，每个Slave内部都存有一个路由表，该路由表由Controller写入。Dynamic routing protocols require more CPU processing and also use a certain amount of link capacity for routing updates and messages.
动态路由协议要求更多的CPU处理工作，并且还需要使用一定量的链路资源用于路由更新和通信。Netsukuku is a separate physical network and dynamic routing system capable of handling up to 2^32 nodes without the need for centralized servers.
Netsukuku是独立的物理网络和动态路由系统，能够处理多达2^32个节点，而且无需中央服务器。RIP is the simplest of dynamic routing protocols and is used in this section to provide a basic level of routing protocol understanding.
RIP是最简单的动态路由协议，用于本部分来提供基本的路由协议理解。
