Examples of using The transfer function in English and their translations into Chinese
{-}
-
Political
-
Ecclesiastic
-
Programming
Figure 2 shows the transfer function of this circuit.
Figure 3 shows a more accurate representation of the transfer function.
The transfer function of PID control is given by:.
Mixed flow design is more convenient to realize the transfer function of passengers.
The transfer function of the PID controller is:.
MGF provides a step by step method to obtain the transfer function from a SFG.
The transfer functions of these token contracts did not return anything.
In artificial neuralnetworks this function is also called the transfer function.
The transfer function, which allows to send tokens from one address to another;
It has been shown in previous installments that the transfer function is basically that of a single-pole filter.
The transfer function of a filter is the Z-transform of its impulse response.
Special attention is required when defining the transfer function to avoid introducing instabilities, such as positive feedback.
The transfer function replacing the old transfer and transferFrom;
For an infinite impulse response(IIR) filter, the transfer function is not a polynomial, but a rational function. .
The transfer function of each statement separately can be applied to get information at a point inside a basic block.
In this, t r a n s b{\displaystyle trans_{b}}is the transfer function of the block b{\displaystyle b}.
The transfer function, in turn, links g(tk) to the corresponding point, u(tk), on the output signal.
Note that g(tk) corresponds to point xk on the x-axis,which reflects, via the transfer function, to point yk on the y-axis.
This model uses the transfer function to model the relationship between predictive variables and explanatory variables.
Band Excitation captures the full tip dynamics during a scan,and therefore let's you see the transfer function or‘cantilever tune' everywhere.
When the transfer function dips below zero,the image undergoes a phase reversal in which dark features become bright and vice versa.
We wish to determine the transfer function H(s) where s= σ+ j ω{\displaystyle s=\sigma+j\omega}(from Laplace transform).
Since the transfer function is linear, calibration is simple, requiring only two-point calibration(or more, if desired) to assure accuracy.
For stability, the transfer function, H(s), is therefore chosen such that it contains only the poles in the negative real half-plane of s.
I believe that the transfer function estimates used in MARGO are based on the traditional method used in CLIMAP, rather than newer approaches.
Significant delays in the Global Service Centre taking over the transferred functions.
(c) Significant delays in the Global Service Centre taking over the transferred functions.