Examples of using Test current in English and their translations into Croatian
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
Products test current estimation method.
High, commercially available test currents are.
And the test current is greater than or equal to 100A.
And phase rotation indicator and test current device RCD.
If there is a built-in fuse,pay attention to the test current.
Test current ripple coefficient: less than 5%;
This method is very cumbersome due to the use of a large test current the DL/T475-2006 standard is recommended to be less than 50A.
The test current adopts the DC 100A recommended by the national standard.
Each load test requires that the rotor current remains stable, andthe variation range should not exceed 1% of the test current;
When the test current is less than 10-10A or the measured resistance exceeds 1011 ohms;
Large LCD screen, display all the data andcurves of the test voltage, test current, time and the leakage current for each item 8 items.
The test current should not exceed the allowable current of the test device.
Large LCD screen, display all the data andcurves of the test voltage, test current, time and the leakage current for each item 8 items.
The test current should not exceed the allowable current of the test device.
Now DC resistance testers are all using the DC bridge method,which requires the test current to be no less than 1A, and the measurement resistance value is small.
Because the test current for the capacitor current, the need for large-capacity test equipment.
In the series resonance state, when the insulation weak point of the sample is broken, the circuit is immediately detuned, andthe loop current rapidly drops to 1/Q of the normal test current.
The maximum test current is 10kV/5A when reverse wiring, power frequency or frequency conversion 40-70Hz.
In the series resonance state, when the insulation weak point of the sample is broken, the circuit is immediately detuned, andthe loop current rapidly drops to 1/Q of the normal test current.
The inter-frequency measurement test current applied in the past ten years The frequency range is about 40-250Hz.
During the test, the high-voltage side is open, the low-voltage side is pressurized, the test voltage is the rated voltage on the low-voltage side,the test voltage is low, and the test current is the rated current percentage.
External high voltage:Maximum test current 5A during positive wiring, power frequency or frequency conversion 40-70Hz.
Adjust LED the simplest method is to change the current and the LED load series of current sense resistor(figure 2 a),almost all DC- DC constant current chips have a test current interface, is detected by internal reference voltage, the voltage and the chip control The current constant.
The test current comes from a high-precision high-current constant-current power supply, which requires no manual adjustment and is quick and accurate.
The measured results, the study discusses the test current frequency and the influence of the arrangement of the measuring leads on the Z, R and X of the test results.
High input impedance:reduced test current and low power consumption, making the product body small and light, stable in performance and high in measurement accuracy.
Loop resistance tester using pulse-width modulated high-frequency switching power supply to provide more than 100A test current, press the measurement button, the high-frequency switching power supply output of more than 100A test current, at the same time sampling circuit to start sampling, the signal obtained by Amplifier amplifier, the A/ D converter converts the analog signal into a digital signal, and then by the microprocessor data filtering, computing, processing, and finally send the display shows the measured current and resistance.
Testing current safely- with the right instruments.
Testing currents: what you need to keep in mind.