Examples of using Not installed in English and their translations into Czech
{-}
-
Colloquial
-
Official
Wireless print server not installed.
If the fax driver was not installed in step 28, it can be installed now.
The grinder cannot be started if the hopper is not installed.
Wireless print server not installed” on page 169.
Unplug alternate air sensor if installed orplug in alternate air sensor if not installed.
People also translate
If the User's Guide is not installed on your computer.
If it is not installed on the air-handling unit by the manufacturer, the capillary tube must be run(meandering way) through the entire cross-section of the water heater's rear side.
LOW NOISE OPERATION LEVEL SETTING() not installed factory setting.
In general the roof has to becleaned carefully after all works performed on the roof and not used and/or not installed material has to be removed from the roof.
This equipment generates, uses andcan radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
A Restore Point records the current versions of all your drivers and programs,which programs are installed and not installed, the current update of Windows, the specific Windows settings, and so on.
This equipment generates, uses and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
This equipment generates, uses andcan radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
This equipment generates, uses, andcan radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.
This device generates, uses, andcan radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio or television reception.
This equipment generates, uses, andcan radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
This equipment generates, uses andcan radiate radio frequency energy and, if not installed and used in accordance with the manufacturer's instructions, may cause harmful interference to radio communications.
This equipment generates, uses, andcan radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.
This equipment generates, uses, and can radiate radio frequency energy,and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
This equipment generates, uses, andcan radiate radio frequency energy and, if not installed and used in accordance with the manufacturer's instruction manual, may cause interference with radio communications.
To view the electronic User Guideon the device CD-ROM(Windows) If you have not installed the device software, you can view the electronic User Guide on your computer by following these steps.
RS485 mode and RS422 mode for COM4(Modbus)therefore only differs in set up by:- Jumper JP11 not installed(RS485) or installed on 120(RS422)- The external wiring for RS422 and RS485 External wiring PCL745 for Modbus.
Because I haven't installed them yet.
You haven't installed a remote monitoring device on someone else's computer… and made $600,000 in two months, have you?
We should be aligning them by now, not installing them.
Furthermore, since service administration requires administrator privileges, securing a VSP against misuse is as simple as not installing the client-side part.
Haven't installed phone lines yet.
But it hasn't installed right.
The serial port wasn't installed correctly.
I haven't installed an opening mechanism yet.