Examples of using Ohms in English and their translations into Czech
{-}
-
Colloquial
-
Official
Meter reads 1 5 ohms.
The Ohms have opened their hearts.
Heater should read greater than 16 ohms.
The Ohms have opened their hearts.
T/C should read 3-50 ohms at room temperature.
The Ohms stopped. They stopped.
Frequency response 30 kilohertz,impedance four ohms.
Into 4 ohms the A-S2000 delivers 2x150W, into 8 ohms it is 2x90W.
The headphone impedance must be between 32 and 600 Ohms.
Digital(Coaxial) Impedance: 75 ohms S/N: 100 dB A, 20 kHz LPF.
W Power Output: 1 to 50 Watts RMS into 4, 8, or 16 Ohms.
COAXIAL IN Input impedance: 75 ohms Supported playback format: LPCM 2ch.
Beyerdynamic DT 880 Semi-Open Headphones, 600 Ohms.
With a mains impedance equal or less than 0.26 Ohms it can be presumed that there will be no negative effects.
Beyerdynamic DT 880 Semi-Open Headphones, 250 Ohms.
The M300 offers mono output of 300W into 4 ohms(150W into 8 ohms respectively) and great 111dB of dynamic range.
The electrical resistance of the copper wire coil is 2.0 ohms.
Sensitivity 86dB, impedance 4 ohms, no bi-wiring.
With quite high sensitivity of 91dB andtraditional wild impedance that dances between 3 and 8 ohms.
The resistance should be between 250 and 350 ohms at approximately 25 ºC.
The headphone impedance must be between 32 and 600 Ohms.
The Nagra Classic integrated amp provides 2x100 watts(into 8 ohms) of power, the output into 4 ohms not specified.
Basic ideal passive andactive circuit elements, Ohms' law.
The bright display shows resistance(ohms), voltage, wattage, atomizer voltage output, puff count, and last-used settings.
The speaker s rated sensitivity is 90dB, the impedance declared to be 5 ohms, dimensions 200x1320x500mm.
The M-600A works in class A up to 2x60W into 4 ohms(it halves its output into 8 ohms) and then automatically switches into A/B.
The tax you pay is slightly less of power: in the Class A the SV-700 provides 2x 50W into 8 ohms, in the Class AB 2x100W.
The contact resistance of the resistance is a very low 8.8 Ohms(typical), the output capacitance is only 5.8pF.
By using a separate power supply(PS Box RS)the power capacity of the system raises the bar to 2x 250 W/ 4 ohms.
On paper the K8's nominal output power is specified to be 150W per channel(stereo, 4 ohms) and transient output power reaches 230W.