Examples of using Rotation speed in English and their translations into Czech
{-}
-
Colloquial
-
Official
Pre-set rotation speed and time.
Switch pressed hard highest possible rotation speed, for boring.
New rotation speed monitor with S0 interface.
Display of deflection angle, rotation speed and torque.
Header rotation speed and operating hours.
When the button(3) is pressed,the knife rotates at maximum rotation speed.
You can change rotation speed during operation.
Rotation speed under no-load conditions Supply voltage.
You can change rotation speed during fan operation.
If you press and hold the button(3),the unit will operate at maximum rotation speed.
The rotation speed of the shaving heads is lower than usual.
Seamlessly adjustable speed- high rotation speed of 4.000- 16.000 rpm.
Work tube rotation speed 1.5 to 10.0 revolutions per minute.
If you press and hold the button(3),the unit will operate at maximum rotation speed.
The rotation speed monitor is easily adjusted via a DIP switch or a PC.
This switch has a built-in, electronic circuit which steplessly varies the rotation speed.
Motor rotation speed does not decrease even when the remaining battery power becomes low.
Turn off the appliance immediately if you notice that it vibrates excessively or the rotation speed has dropped.
HDD Rotation Speed- this parameter shows how fast the discs of an HDD are rotating.
Econo operation reduces power consumption of the outdoor unit by limiting the rotation speed of the compressor.
Setting the leaf rotation speed and the rotation enable time enabled passage.
However, it is difficult to know the remaining battery power from the rotation speed and the tool may stop suddenly during work.
If the rotation speed of the strainer wheels is too high, then the beet is damaged.
The driver allows you to switch the rotation speed of 4 speeds and turn on/ off the fan.
The rotation speed value is provided as a binary signal by a NAMUR sensor or a mechanical contact.
Smooth start andstopping of the arms and setting the rotation speed according to the gate leaf's size and material assure safe passage.
Rotation speed monitoring synchronization monitoring, transimtter power supply with programmable high or low alarm.
Since this tool adopts the constant-speed control, the rotation speed is almost unchanged even when the remaining amount of the battery becomes low.
The operation display permits convenient selection andstorage of parameters such as rotation counter, rotation speed, grinding time, start and stop.
Due to its S0 interface, the rotation speed monitor is also suitable for areas outside industrial automation, such as building automation.