Examples of using Inductive load in English and their translations into Dutch
{-}
-
Colloquial
-
Official
-
Ecclesiastic
-
Medicine
-
Financial
-
Computer
-
Ecclesiastic
-
Official/political
-
Programming
W ith inductive load ohmic share min.
Relay contacts N.O.: 5A 3A inductive load.
With inductive load and strong fighting force.
Max. phase shift with inductive load: 30°.
(4) Inductive load starting power is too large.
Max. phase shift with inductive load: 30°.
For inductive loads, pure sine wave inverter is necessary.
Pure sine wave output, can take all inductive loads.
Protection at too inductive load can be disabled for dimmable led lamps.
Suited for both resistive and inductive loads.
Inductive loads: according to the load,
Or wound transformers(inductive load, leading edge).
Yes, a component protects output contact against inductive loads.
Protection for resistive and inductive load with low inrush current.
VMBDMI- Single channel triac dimmer for resistive and inductive loads 5.
Approvals Note Inductive loads(contactors, relays
Switching capacity with an inductive load: 8A/230Vac max.
AC: 50 W at 230 VAC resistive load or 25 W at 230 VAC inductive load.
It can also control up to three inductive loads like relays or motors.
A phase angle dimmer can be used to dim ohmic or inductive loads.
resistive or inductive load, for capacitive load current derate by 20%.
Models for switching of resistive and/or inductive loads.
But if it is inductive loads and capacitive loads,
Minimum load with leading-edge dimming(inductive loads): 50 Watt.
VA AC, 54 W DC If inductive loads or stronger currents are switched through,
Mixed loads allowed no capacitive and inductive loads together.
Modified wave can be started with some inductive loads, but effect for load using life, because capacitive loads and inductive loads need high quality power.
transient suppression for use with inductive loads.
used to eliminate the inductive load in the loss of electricity generated when the acoustic power to suppress the resulting interference, to prevent the drive components
Accurate peak measurements can be taken using the in-rush current mode, ideal for motors and inductive loads.