Examples of using This byte in English and their translations into French
{-}
-
Colloquial
-
Official
This byte is reserved for an interrupt.
Coil 27 is the MSB of this byte, and coil 20 is the LSB.
This byte helps you to troubleshoot the disconnection.
Nlc will undertake a retrospective conversion of this byte.
This byte identifies the type of data stream("stream-- id".
The information given by this byte may be one of the given below.
This byte may end with one of a plurality of null bytes. .
We wait for the end of this byte before starting the next HDLC frame.
This byte must talk about to each one of the bits of the record.
In other cases,such as aftertouch, this byte is unused.
If the value of this byte is changed, the identity of the partition is changed.
The channel then requests an interruption to transfer this byte to main storage.
After removing this byte, they were able to proceed to the sixth and final level.
Type of Subject Subdivision- Value used before the definition of this byte[OBSOLETE.
The information given by this byte may be one of as given in the following table.
This byte transits on the data bus 18 to the register 12 a of the protection unit 4.
Coil 56 is in the fourth bit position from the left, andcoil 52 is the LSB of this byte.
Note: This byte can be modified regardless of which emulator you wish to use.
The table in question being TABLE1,the name of which comprises six characters, the value 6 will be carried in this byte.
This byte, for which all stations are sinks, is placed at the end of the database.
In order to ensure unambiguous interpretation of coding,nlc will undertake a retrospective conversion of this byte.
Key(1 byte='50') This byte indicates that the next data are a response.
This byte makes it possible to signal, to the interrogator unit, the start of the sending of a message.
The other coils follow toward the high order end of this byte and from'low order to high order' in subsequent bytes. .
However, this byte overwrites some critical data when the string fits some specific length.
If there is a power failure, or the Power switch of the computer is accidentally turned OFF or the system is manually rebooted due to some software problem,then this byte will remain as 07H or F7H which informs the Windows Operating System when next time it is booted that there was some kind of improper shut down and then Windows uses it's disk scanning program(Scandisk) to verify the disk for errors.
This byte can be used to find the type of the disk media of which this FAT entry is.
In the next cycle,G2, this byte is read from address zero to the out select gate.
This byte contains the code associated with the frame to facilitate its decoding by the data system.
If the contents of this byte is the letter A(OFF) then the program moves on to the next auxiliary meter.