Examples of using Attack time in English and their translations into German
{-}
-
Colloquial
-
Official
-
Ecclesiastic
-
Medicine
-
Financial
-
Ecclesiastic
-
Political
-
Computer
-
Programming
-
Official/political
-
Political
Attack time: 2 figure, red 23 cm.
Rotary knob“Attack” with input/ indication field for the attack time.
Adjustable attack time from 2 to 50 ms.
The semi automationcalled Auto Fast automatically shortens the attack time on fast and loud signal impulses.
The attack time is set with the Attack slider.
With some experimentation the effect can be that of“zero,” attack time at any given frequency.
Attack Time before compression reaches its full value.
Limiter: A limiter works like a compressor with an infinitely high compression ratio andan infinitely short attack time.
VirtuE's attack time was not effective enough, so PACT ended up winning.
The functionality andresponse of a limiter is determined by parameters called attack time, threshold and release time. .
The attack time starts at 0.01 milliseconds and ends at 150 milliseconds.
Ratio 1: 1(minimum) Threshold Level 0(minimum) Attack Time 0.2 ms(minimum) Release Time 50 ms(minimum) Key switch.
Attack Time: Click this menu to set how long it takes for the dynamic control to compress the signal.
Further functions: freely configurable release- and attack time, a wide range of display settings, several Quality factors and special display modes.
The attack time determines how fast the compressor reacts to the level going above the threshold.
For example, if you set the attack to 80 ms andthen engage the Auto Fast mode, the attack time will be shortened automatically on fast and loud signal impulses.
O Attack Time: Select this to set how long it takes for the dynamic control to compress the.
To understand how a compressor works, it is necessary to become familiar with the basic parameters which include threshold,ratio, attack time, and release time. .
Limiter Section The attack time determines how fast the compressor reacts to a signal above the threshold.
Parameter 2(Limit)- This sets the maximum level that the compressor will allow on the output even thoughtransient peaks may exceed it for a short time since the attack time isn't instantaneous.
Attack Time: Click this menu to set how long it takes for the current signal to be fully attenuated.
Auto Fast' means that the attack time is automatically adapted to the source material, becoming very short on fast transients.
The attack time varies between 0.01 and 150 milliseconds and therewith offers very effective compression even of fast transients.
Threshold: Switchable: 0, +4, +8, +16 dBm Attack Time: 1 ms± 0.5 ms Release Time Constant: 100 ms± 30 ms Indicator: Green when limiting by 1 dB or more.
The attack time works with very fast 0.01 to 150 milliseconds and the release covers a range from 5 milliseconds to 1.2 seconds.
If the compressor's attack time is set fast enough, the gain reduction can begin acting within one cycle of the sound wave.
Normally, an attack time of 0 ms would create a click, which is why the attack time of compressors starts only at 0.1 ms. With this workaround, you can achieve 0 ms and thus very tight sidechain compression.
On fast and strong signal impulses, the attack time will automatically be reduced to its fastest value, and after this it will automatically return to the value which has been set with the controller.
Envelope Attack Time(Attack)- This sets the time it takes for an envelope to reach the peak level, starting from the initial level.
If the mpressor is used on group channels with a longer attack time, an additional semi-automation called Auto Fast keeps track of the input signal: If a signal with a short, very loud attack appears, the mpressor will react with reducing the attack time only for this critical passage.