Examples of using Auto-negotiation in English and their translations into German
{-}
-
Colloquial
-
Official
-
Ecclesiastic
-
Medicine
-
Financial
-
Ecclesiastic
-
Political
-
Computer
-
Programming
-
Official/political
-
Political
Auto-negotiation of full- and half-duplex.
Network 100 Mbit/s, with auto-negotiation.
This saves auto-negotiation of new modulation.
UTP 100Mbps Full Duplex mode UTP Auto-Negotiation.
Auto-negotiation for the port must be disabled.
All RJ45 ports support auto-negotiation and AutoCross™.
Supports Auto-MDI/MDI-X, full/half duplex modes and auto-negotiation.
Both interfaces support Auto-Negotiation and Auto-MDIX.
No, auto-negotiation is not supported between the 10 GE and 1GE speed.
The Copperport provides Auto-Negotiation and MDI/MDI-X function.
Auto-Negotiation(Full-duplex, Half-duplex) Security 64/128-bit WEP, WPA, WPA2, WPA2-Mixed.
Disables the flow control when auto-negotiation is enabled.
Note: If auto-negotiation is disabled, no flow control takes place.
Port 1-4 will be isolated respectively(10Mbps auto-negotiation), but can communicate with the Uplink port.
Through auto-negotiation and Auto-MDIX, it automatically matches connections to the attached equipment.
Avoid operating device in 10Mbps full duplexmode if the device does not have auto-negotiation function!
Data rate: 10/100Mbps auto-negotiation and half-/Full-duplex mode on TX port.
Default Mode: If Default mode is enabled,the device works as a general switch and all ports support 10/100Mbps auto-negotiation.
Auto-negotiation can determine whether Clause 74 FEC, Clause 91 FEC, or no FEC is employed on the link.
Though copper SPFs support 10/100/1000 auto-negotiation but optics like SFP and SFP+ don't support auto negotiation by any means.
The Dell Networking N1524/N1524P front panel provides 24 Gigabit Ethernet(10BASE-T, 100BASE-TX, 1000BASE-T)RJ-45 ports that support auto-negotiation for speed, flow control, and duplex.
The GBIC transceiver is compatible with 1000BASE-X auto-negotiation, but does not have a link indication feature RX_LOS is internally grounded.
If auto-negotiation is enabled, the flow control is performed automatically according to the capabilities of the partner symmetric, asymmetric.
Ensure that the routers are using the correct optical transceiver, auto-negotiation is disabled, and port speed and full-duplex mode are manually configured.
The Ethernet port supports auto-negotiation for speeds from 1 Gbps to 100 Mbps, making it a very flexible solution for any environment.
It provides 5 10/100/1000Mbps auto-negotiation ports, which you can use to establish a LAN network, or extend the uplink network.
The Ethernet port supports auto-negotiation for 10 Gbit/s, 5 Gbit/s, 2.5 Gbit/s, 1 Gbit/s and 100 Mbit/s, making this a very flexible solution for any environment.
It supports 10/100Mbps auto-negotiation on all ports, for seamless migration to 100Mbps connections without time-consuming trips to the wiring closet.