Examples of using Default policy in English and their translations into German
{-}
-
Colloquial
-
Official
-
Ecclesiastic
-
Medicine
-
Financial
-
Ecclesiastic
-
Political
-
Computer
-
Programming
-
Official/political
-
Political
Restricted" is the default policy.
The default policy is deny access from all initiators.
SYNC_NONE: This is the default policy.
The default policy allows full access to the AWS service.
Create an empty policy default policy for clients.
This issue does not reproduce after cloning the default policy.
First, save the default policy for your CMK as policy. .
If you use the Default policy, make it the last one in the list.
For AWS:: RDS::DBCluster resources, the default policy is Snapshot.
Note: Default Policy Typed from the System cannot be deleted.
IPFILTER_DEFAULT_BLOCK- This option sets the default policy of ip-filter.
The default policy specifies the groups and settings in the following table.
Creation of the MRS addresstype in the“Exchange System Manager” under“Default Policy”.
Select your default policy for clients, click the gear icon and select Edit.
It is used for applying of Policies for each computer as a default policy.
Click the default policy and"Edit" to edit the default policy.
If you see a policy similar to the following,you have only the default policy set.
Select your default policy for clients, click Policies and select Edit.
If no LUN masking policy is specified for a connected iSCSI initiator, the default policy will be applied.
The default policy is one described in RFC 3484 when ipv6_enable is set to YES.
This is pretty intuitive, and the default policy comes preconfigured and already applied….
The default policy is only applied if no state configured as part of the conditional policy is true.
If the kernel is compiled with the IPFIREWALL option,be aware that the default policy is to deny all packets that are not explicitly allowed.
Configure the default policy and define a state that will trigger a policy change by using the following two procedures.
NOTE: A policy may be linked to other servers orpolicies as a parent policy, as a default policy for lower servers, as a default policy for primary clients, etc.
Based on the default policy, NPS authenticates users and computers that have an account in the local domain and in trusted domains.
When no policy has been set by a management application, the default policy that is used by the DSM is either Round Robin, when the storage controller follows the true Active/Active model, or simple failover in the case of storage controllers that support the SPC-3 ALUA model.
New default policy for primary clients- If the deleted policy serves as a virtual policy(see section Global Policy Settings), it must be substituted by another one for more information, see chapter Virtual policies. .
P- Sets the default policy for the specified chain, so that when packets traverse an entire chain without matching a rule, they are sent on to the specified target, such as ACCEPT or DROP.