Examples of using Electrical input in English and their translations into German
{-}
-
Colloquial
-
Official
-
Ecclesiastic
-
Medicine
-
Financial
-
Ecclesiastic
-
Political
-
Computer
-
Programming
-
Official/political
-
Political
Electrical Input: 100 VAC- 240 VAC.
The sensor has a 3-wire electrical input: N, L in, L out.
Electrical input at the standby mode W< 15.
Automatic USB voltage regulator guarantees stable electrical input for EB01.
Electrical input at the nominal output W 42 78.
The required power to run the heat pump can be delivered either by electrical input or by natural gas.
Electrical input at the minimal output W 31 52.
Overall Frequency Response 26Hz-40 kHz 32Hz-40 kHz 33Hz-40kHz Sensitivity 90dB 90dB 89dB Electrical Inputs Dual gold-plated 5-way.
Electrical inputs: Digital control RS 232: 9 pole, SUB-D.
The motor efficiency(n)is calculated on the basis of the ratio between the shaft output power(POUT) and the electrical input power PIN.
Electrical input at the standby W-< 5.
The power control is performed directly based on theconsolidation and sterilization process, and no longer on the electrical input values.
Electrical input at the nominal output W- 38.
Optical Transceivers are hot-pluggablemodules that provide optical connectivity by converting electrical input to optical light and, with the help of sensors, sending it through an optical cable.
Electrical input at the minimal output W- 19.
When comparing motors at different operating voltages,you may prefer to have the horizontal diagram axis refer to the electrical input power instead of the current.
Electrical inputs for humidity and temperature transducers eliminate the need for additional displays.
In this way, it is possibleto relatively easily build electrical amplifiers with transistors that have a small electrical input wattage and a large electrical power output since the control current IB is e. g.
The programmer is fitted with an electrical input monitoring system, which is used to block the motor in emergency conditions; however this system is not active during the following stages.
The main difference is that instead of transmitting electrical impulse, the fiber patch cord transmits optical light and with the help of opticalequipment this light is then converted in electrical input.
After measuring the electrical input, the magnet is ripped to get to the coil inside.
The fiber optic transceiver is a type of self-contained,hot swappable component that has the capability to convert electrical input into optical signal and vice versa, and with the help of lasers transmit these optical signals(optical light) down the optical cable.
These transceivers convert the electrical input gotten of the device into an optical light and, with the help of the optical cable, this optical light is sent to the other side of the connection so that the other end transceiver can take it and convert it into an electrical signal that the device can handle.
The programmer checks the electrical input to the motor, detecting any eventual increase in effort above the normal operating limits and intervenes as an additional safety device.